0
Check for a blown fuse.
If fuse is good remove blower and check for power at the blower motor plug using a multimeter or voltage tester. If power is available replace the blower motor. If power is not available you can do a running check by directly hooking up a 12 vdc power supply to the blower to see if it will even run.
If the blower runs, your problem is your most likely the fan speed control resistor which will need to be replaced or repaired.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
A diagram for a starter for a 98 Ford Contour?
i need diagram for a starter a 98 ford contour
Will the engine from a 98 contour svt fit the transmission of a 98 contour se?
check this link out
Will 98 ford contour tires work on a 98 ford escort?
No
What Reports are available on 1996 Oldsmobile regency 98?
RE: 96 OLDSMOBILE 98 REGENCY ELITE, V-8, 3.8 WHAT PART NEEDS TO BE REPLACED SO THE A/C AND HEAT VENTILATION WILL BLOW OUT OF THE FRONT VENTS AND NOT ONLY THE DEFROST?
Do 95 Ford Contour hoods match 98 Ford Contour?
No the head lights are designed different from 95-97 to 98-00.
Why wont the AC and heat fan blow in your 98 Jetta you checked the fuse and its fine?
Defective blower motor, switch, or resistor pack.
Does the 98 contour clock have lights?
Mine doesn't
98 Ford Contour 2.0 turns over and wont fire seems like its not getting gas. fuel filter just been replaced.?
Make sure you did not put it in backwards.
You have freon in the ac system on a 98 windstar but the compressor wont turn on?
Fully charged? Bad pressure switch on accumulator/drier? Blow fuse?
Why in my 98 Ford Mustang my air conditioner will not blow out to the face or feet?
If it's stuck on defrost, the problem is most likely a small vacuum line near the rear of the engine by the firewall. Mine broke right at a junction.
How Do You Remove An alternator on a 98 Ford Contour?
take off the screws
Why does the blower 98 Intrepid only blow on high not low or intermediate?
Defective blower motor resistor module. this is true except if the control module is malfunctioning at which point the defrost goes to emergency mode in which the defrost will stay on permanently. My module will not power up and I need help with wiring schematics to find a bad ground or power wire
