average +/- the highest minus the lowest value/2
would be the final answer
Both accuracy and precision are important to scientific measurement. I'll try to explain the difference with a couple of illustrations. I should start by saying, sometimes the words are used interchangeably but they shouldn't be. I consider precision to mean resolution. That is how fine/small a reading you can get.Assume an electronic thermometer (digital display) can display answers to the nearest one hundredth of a degree. But, the thermometer isn't able to measure with that accurately. Maybe it's only accurate to the nearest whole degree. In this case the precision is greater than is supported by the accuracy of the device.Now take the opposite case where the thermometer is able to measure temperature accurately to one hundredth of a degree but the instrument can only display whole degrees. In this case the precision does not support the accuracy.Ideally the accuracy and precision of an instrument are the same but often that's not the case.
Precision measurement is that which has maximum uncertainity
nothing
the precision of the least precise measuement
the precision of the least precise measuement
precision
They have the same value but not the same degree of precision.They have the same value but not the same degree of precision.They have the same value but not the same degree of precision.They have the same value but not the same degree of precision.
precision
the answer is you have to use the right instrument on somthing to get the right answer
''Accuracy is the degree of closeness to true value. Precision is the degree to which an instrument or process will repeat the same value. In other words, accuracy is the degree of veracity while precision is the degree of reproducibility.
precision
it implies the degree to which the strate choosen for research is apt
It is a specified degree of accuracy or precision.
2.840, although that DOES imply a greater degree of precision.
A precision resistor is a resistor that has an actual value that is very close (or precise) to its nominal (or stated value). Therefore, precision resistors have a very degree of accuracy of being very close to their nominal values.
If a number is given to the true degree of precision, this is always determined by its last digit - in this case, 6.
3.50 is equal but it implies a greater degree of precision.