answersLogoWhite

0

gas and propane stoves have pilot lights, these must be lit by depressing a pilot control knob, the stoves will then light when the control knobs are turned to open/ on position

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is one way to describ a bad sentence?

I don’t know


What term is used to describ the way a virus is passed to host organism?

vectoring is the right answer


What is the best way to replace a stove light bulb?

To replace a stove light bulb, first make sure the stove is turned off and cool. Locate the bulb cover, usually at the back of the stove, and remove it. Unscrew the old bulb and replace it with a new one of the same type. Screw the cover back on and turn the stove back on to test the new bulb.


Correct way to use the word on?

Turn the light on. Why is the fan on? Come on the train. These are all examples of how to use on... the correct way. hehe


What is the correct way to install an electric stove according to the wiring diagram?

To correctly install an electric stove according to the wiring diagram, first turn off the power supply. Then, follow the diagram to connect the wires from the stove to the corresponding terminals in the electrical panel. Make sure to secure all connections properly and test the stove before use to ensure it is working safely.


What are some tricks to light a candle?

A cool way to light a candle is to use the stove if you have a gas one. Or you can take two boxes of matches and rub them against each other next to the candle.


Is it proper to say the lighted side of the moon?

No, the correct way to say it is: "The light side of the moon"


What is a way that liquid can become a gas?

Use a stove


Does salt water produce energy?

yes it does the ions in the salt become energy. if you were to make a circuit the correct way with a light bulb there shall be light.


What is the best way to clean a flat stove top?

A flat top stove should be cleaned with warm soapy water.


Can you connect a 15A 120V circuit to one phase of a 240V stove circuit without overloading the stove circuit?

Short answer: probably not. Longer answer: It depends on the size of wire feeding the stove, the stove amperage, and what you intend to connect to the new 15A circuit. If you just want to wire a light for the garage, sure go ahead. If you want to install a receptacle for a microwave oven, no way. Make sure you put a fuse to protect the circuit you are connecting.


Is it unsafe to boil broccoli on the stove?

No. it is a good way of cooking it.