0
go to autozone.com enter your vehicle. then look up struts on the main page and there will be a link that says repair guide and your home free hope it helps
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why is my Dodge Neon shaking in the rear?
It could possibly be a strut or a strut mount failing. Try calling Dodge ( 1(800) 992 1997 ) with a request to check the recalls on your Neon.
Where do you get a vaccume line diagram for a 87 Chevy celibrity 2.5 tb?
there should by a diagram on passenger side strut mount under the hood.
Can you show me a Diagram of a strut assembly?
There is a few place you can find a diagram if a strut assembly. You can find a strut assembly diagram online or at an auto part store.
How do you change a strut mount on a Mitsubishi montero?
The bottom strut mount is connected to the frame by two retaining bolts. Remove the retaining bolts to remove the strut mount. Reverse the process to install the new strut mount.
1985 camaro strut mount bracket doesnt fit new strut mount i cant find a new strut mount bracket at the dealer or NAPA where can i get a new strut mount bracket?
E-Bay?Hemming's Motor?
What is the purpose of the strut mount 2002 alero?
the same as every strut mount. to hold the struts
How to replace motor mounts in 1995 dodge neon?
You've got 4 mounts total. A transmission mount, then on the other side of the motor, you've got a mount that goes to the middle of the engine that is in the fender, and upper torque strut and a lower torque strut on that same side.
Where is the strut mount Saturn SL1?
there are 4, each above the strut holding the spring on
What does a strut mount look like?
see link below..
What is a strut bearing plate?
The top of the strut is connected to the vehicle body through the upper strut mount, in some cases called a bearing plate. This bearing plate allows the strut to pivot as the wheels are turned. It must be flexible enough to handle slight angle changes and dampen movement of the upper end of the strut. This mount or bearing plate transfers vehicle load to the strut and spring, making the upper mount/bearing plate the load carrier and the lower ball joint the follower.I found this on the Monroe site.
2005 Chrysler town and country. there is a loud bumping noise that sounds like something is loose but I can find no loose components. Has anyone an educated guess?
I believe the 2005 is the same as the 2002. The upper strut mount has a large rubber mount inside the upper strut mount. The rubber gets old and detaches from the upper mount. If you put your finger inside the upper mount and touch the top of the strut shaft with your finger, rock the car back and fourth pretty vigorously and if the center shaft moves the upper strut mount needs to be replaced.
What causes rattling noise in front end of ford escape when hitting a bump?
Could be a loose or worn strut or strut mount
