http://wiki.answers.com/Q/What_is_the_difference_between_rg6_and_rg11"
This is "quad shield RG-6". It has four layers of shielding; regular RG-6 has only one or two. 1mm core.
RG 56 has a 1.48 mm core with dual/quad shields.
The "F" connector is the most common type that is used on RG6 cable. This is the universal connector for home use of RG6 with antennas, CATV, satellite, and consumer electronics.
I could be wrong, but I believe you are talking about an HDMI cable. Between the antenna and the TV set use RG6 cable.
yes RG6 should be used exclusively for satellite hookups and digital CATV. RG59 is fine for analog CATV signals but will not support the higher bandwidth used for satellite signals.
what is difference between dynamic and volumatic compressor
what is difference between mild steel and stainless steel
RG6 specifies a family of co-ax cables with similar characteristics. Within the family, there are several variations such as the materials used, screening and other characteristics. To select the right cable, there is no alternative to looking at the data sheets supplied by all manufacturers. Remember that there are quality variations between manufacturers, so if you can't get a data sheet from a supplier, look elsewhere. All of the better quality suppliers will be happy to provide a data sheet. Those who won't give you a data sheet may have something to hide or simply don't know the performance of their own cable. RG6 quad just means 4 layers of the thin silver insulation. The difference between rg6 and rg6 quad is negligible.
When comparing the two of cable, 3C2V has smaller diameter than RG6. RG6 cable can sometime be seen as Quad shield cable. Both these cable can be used in TV signal receiving but RG6 is the most suitable when receiving digital signal such as satellite television and DVB-T.
RG-11/U is 75ohm and is usually triple/quad shielded and typically has a maximum attenuation of 3.65. RG-213/U is common form amateur radion and is 50 ohms and is single shielded with about a 5.95 attenuation.
The "F" connector is the most common type that is used on RG6 cable. This is the universal connector for home use of RG6 with antennas, CATV, satellite, and consumer electronics.
For Dish Network, we use RG6 coax cable to allow a higher frequency range for the satellite signal from the dish to your receiver. Any coax cable not rated at RG6 could affect the signal.
I could be wrong, but I believe you are talking about an HDMI cable. Between the antenna and the TV set use RG6 cable.
We use a RG6 coax cable from the dish to the receiver. The cable used between the receiver to the TV varies.
VoIP cables are RG11 for phones lines and UTP RG45 for internet connection.
rg6
One can purchase RG6 coaxial cable from a variety of different places. You can try your local electronics store, a TV stockist, or a large department store. You can also try Amazon.
No
yes RG6 should be used exclusively for satellite hookups and digital CATV. RG59 is fine for analog CATV signals but will not support the higher bandwidth used for satellite signals.