no
Strain gage and Extensometer both are same purpose to check the stress and strain in selective test pieces, but traditional they were using strain gage its take the preparation time is high and Extensometer we are check the directly both results are same.
The normal strain is a deformation caused by normal forces such as Tension or Compression that act perpendicular to the cross-sectional area, while the shear strain is a deformation obtained from forces acting parallel or tangential to the cross-sectional area.
I think torsional strain happens only when two groups are eclipsed in relation to their positions to each other. This strain can be relieved by rotation about the carbon carbon bond. But steric strain can happen all the time. (when two groups are eclipsed, gauge or staggered in relation to each other.)
proportional limit is value of stress that beyond which it is nonlinear; prior to that the stress strain diagram is a straight line. At yield, the material strain will not return to zero after unloading and have a permanent set
Young's modulus
there is no difference
difference between Strain-stress diagram of copper and steel?
Strain is the measure of length change per unit length. Elongation usually refers to strain under load at failure point.
Strain is further division of species and different in gentics level with other strain while clone is genticially and morphology similar to parent cell
A strain is damage to a muscle. It can be as little as a 'pull' or as bad as a tear in the fabric of the muscle.
Strain
Strain gage and Extensometer both are same purpose to check the stress and strain in selective test pieces, but traditional they were using strain gage its take the preparation time is high and Extensometer we are check the directly both results are same.
Strain gage and Extensometer both are same purpose to check the stress and strain in selective test pieces, but traditional they were using strain gage its take the preparation time is high and Extensometer we are check the directly both results are same.
The normal strain is a deformation caused by normal forces such as Tension or Compression that act perpendicular to the cross-sectional area, while the shear strain is a deformation obtained from forces acting parallel or tangential to the cross-sectional area.
A sprain is an injury in which a muscle is overstretched or torn. Tendinitis is an injury that occurs when a tendon becomes inflamed or torn. That's the difference between a muscle sprain and tendinitis.
Strain aging could be described as " normal wear and tear " or the fatigue that is experienced under normal conditions, whereas Dynamic strain would be an out of the normal range stress condition like a one time over stress condition where the sum of much strain aging is experienced in one " dynamic" occurrence.
A strain is an overstretched or "pulled" or torn muscle. a sprain is an overstretched or torn ligament (holds bones together at a joint), and a fracture is a crack, chip, break or crush of a bone.