I'm not sure if you are speaking of a specific instance.... However, a digital signal is a binary representation of the analog signal. The analog signal is constantly measured and the amplitude (voltage at the time of sample) of the analog signal is converted to a binary number at specific intervals (the frequency of the sample rate). The higher the frequency of the sample rate, the more accurate the representation of the analog signal.
Analog signal is continuos one where as digital is discrete (either HIGH or LOW).
The basic difference is that in analog modulation the modulating signal is analog signal and in digital modulation it is in digital form.
The main difference between the tow is the signal. VGA uses an analog signal and DVI is a digital signal.
we can do analog signal processing also but it is very expensive as comparing with digital signal processing that's why we generally choose the digital signal processing.DSP allows programmable operations.But we cannot do in ASP.
Analog signals are continuous while digital signals are discrete
An DAC convert digital signal to analog signal i.e Digital to Analog Converter. An ADC convert analog signal to digital signal i.e Analog to Digital Converter.
Analog communication considers infinite amplitude levels. But in digital communication only 2 levels of signal is present.
In a analog transmitter the RF carrier have to be modulated with the analog signal either by AM or FM where in digital transmitter the carrier is simply switched on and off a off = a zero and on = a one
When you convert digital signal to analog, it is called as an analog signal. The device used is called digital to analog converter.
There are four possible combinations of encoding techniques -Digital data, digital signal -Digital data, analog signal -Analog data, digital signal -Analog data, analog signal
The most fundamental difference, I would say, is that Amplitude Modulation (AM) is a kind of Analog Modulation Technique (the modulation is applied continuously in response to the analog information signal) where Amplitude Shift Keying is a type of Digital Modulation Technique ( an analog carrier signal is modulated by a discrete signal, digital modulation methods can be considered as digital-to-analog conversion, and the corresponding demodulation or detection as analog-to-digital conversion. The changes in the carrier signal are chosen from a finite number of M alternative symbols).
1. Digital Signal is non-continuous signal where as analog is continuous signal 2. Digital signal contain only two value that is 0 or 1,or high or low where as analog contain all the values in it's time interval 3.Chance of attenuation in analog is more then digital signal
The basic elements in digital signal processing are an analog to digital converter, digital signal processor, and digital to analog converter. This process can take an analog input signal, convert it to digital for processing and offer an analog output.