answersLogoWhite

0

Yes, if you want the stereo to perform to it's best, you should purchase one of these.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why does an operational amplifier need a power supply?

It doesn't. You can make a differential amplifier with a single power supply.


Do you need a Amplifier for 6x9 speakers?

You need an amplifier for any speakers if they are to function.


Can you install an amplifier to a factory 2000 Jeep Grand Cherokee stereo?

yes , you need the converter from high to low, found at walmart, connect to speakers, if have factory amp install before the amp


What is a 1 channel amplifier?

A mono amplifier. You need two for stereo.


What is the need for differential amplifier?

A differential amplifier will amplify the difference between 2 signals. This is useful in control systems, where one signal can represent what is actually happening (could be a position or speed, for example). The other signal can represent what is desired. A differential amplifier could be used in a cruise control on a car. When you set the cruise control, a voltage level can represent the speed that the car was traveling when set. If the car starts going up a hill and slows down, the voltage difference would be amplified, and the output of the differential amplifier can be sent to an actuator, which moves a lever to increase the rate of fuel going to the engine. When you get back to the desired speed, the difference is zero, and the actuator stops moving. If your speed increases too much, then it would have a negative voltage, so the actuator would move the other way, decreasing the rate of fuel to the engine.


How do you wire an amp to a 2006 Chevy Cobalt factory radio?

To wire an amplifier to a 2006 Chevy Cobalt factory radio, you'll typically need a line-out converter to tap into the speaker wires since the factory radio doesn't have RCA outputs. First, locate the speaker wires at the back of the radio and connect the line-out converter's inputs to these wires. Then, connect the RCA outputs from the converter to the amplifier. Finally, connect the power, ground, and remote turn-on wire from the amp, making sure to follow proper safety and electrical guidelines.


Can you use diode as trangister?

A: YES but not directly. for instance a discrete differential amplifier one side need to be a transistor to recover gain but the other transistor can be a diode since in real time that is the operative base to emitter current difference. .


How do you hook up a sub woofer in a 1999 civic si with a stalk deck?

What you need is a Speaker Wire to RCA converter. You can find one at about any car audio store, I.E. Best Buy, or any car audio place. They can run from 25-30 but you may be able to find a budget model if you look long enough. What is does is converts the signal from your Deck to a signal the Amplifier can understand. You just connect your RCA cables to the converter and run them to your amplifier. Then connect your subwoofer to the amplifier. Quite simple process and can easily be done. Ensure your subwoofer is compatible with your amplifier as far as OHM's go or you will blow it. Just some extra G Whiz info.......


If your TV has RCA audio out you do not need the converter.?

If your TV has RCA audio out you do not need the converter.


How do you replace the amplifier in a 2002 ml 500?

How do you replace the amplifier in a 2002 ml 500? i need to know where in the 2002 ml500 i can find the audio amplifier


Why you need operational transconductance amplifier?

Usually output of an amplifier is a voltage ,...but in case of Operational Transconductance Amplifier ,Iout (current ) is the output. This feature, makes it useful for Electronic control of amplifier gain .


Do you need a amplifier for a DJ set?

You DO NOT need an amplifier for a dj setup. Some speakers now come with a built in amp, known as a "POWERED SPEAKER".