answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Do a uno 1.1 starter motor fit on a fiat palio 1.2?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does mk2 golf 1.6 starter motor fit mk2 golf gti?

Yes, a starter motor from a 1.6 will fit a 1.8 and vice versa.


Fit a starter motor on vectra cdti 55?

Yes, a starter motor can be placed in a Vectra CDTI 55.


How difficult is it to Fit a starter motor for peugeot 306?

i dont know how to fit a stater moter!!


Will a sbc 350 starter motor fit a sbc 400?

Yes.


How do you fit a starter motor on a diesel?

to fit a starter motor it is normally held in by 3 maybe 4 bolts dependant on what car it is. these bolts are normally easily found when the starter motor is found which will be located either on the back or the front of the engine. attached to the gearbox. there is aso the main feed wire connected to the starter which must also be removed but always remember to disconnect the battery terminals before removing the starter.


Will the starter motor from a Nissan CD20T fit a CD20 ok?

yes without a problem


Does a Fiat Stilo gearbox fit Fiat bravo?

yes


Does vauxhall alloys fit a Fiat?

No! Fiat 4x98 Vauxhaul 4x100


How do you fit a starter motor to a suzuki sv 650s?

Undo the power wires, remove the cover bolts and pull out.


Motorcycle starter motor?

Basically motorcycle starter motor spark up the engine initially but you can start up even without starter motor. 0nce you're rolling at a reasonable pace, release the clutch so that the spinning rear wheel begins to turn the engine over. This is exactly the same as using the starter motor, except you're using the momentum of the bike instead of the battery.


Will a Toyota 22r starter fit a evo harley motor?

I use a starter solenoid from a 1991 - 1995 Toyota Pickup on my 1998 FLHT Evo... and a fraction of the cost from Harley.


How do you change a starter 1992 pathfinder?

if it is an automatic transmission it is a real nitemare. you have to remove the two transmission coolent lines from the radiator, then you have to slide the starter out through the front of the motor, in between the motor mount and the engine, it will only fit if you get it just right.