The tow bar fitting instructions will say if you need to make a cut they will also give the dimensions if a cut is needed
Bumper cover or fascia.
You must remove the bolts that connect the bumper to the frame from underneath the rear of the truck. Have someone hold the bumper so that it does not fall on you when you remove the bolts.
there are 2 bolts on the side of your bed inside. its a 10mm bolt, unscrew and then the light comes out.
no problem you have alot of torque the problem is the mpg and braking
in back in gap between bumper and bed there should be a slot for jack handle to fit through to crank
How to remove the front bumper to a 1998 Nissan Altima?
how to replace rear bumper brackets on a 2002 Nissan sentra
I tow my boat with a tongue weight of about 140 pounds and a tow weight of 1500 pounds and the truch handles ok but the bumper has started to sag at the hitch
Bumper to bumper, 16' 0.3", (192.3")
Super glue
YOU HAVE TO REMOVE THE GRILLE, 4 PLASTIC BOLTS ON TOP, TWO TURN PLASTIC BOLTS ON EACH SIDE AND CLIPS ON THE INTERIOR. THEN REMOVE THE FRONT SECTIONS OF THE PLASTIC INSIDE WHEEL FENDER SO YOU CAN GET TO THE TWO BOLTS ON EACH SIDE THAT HOLD THE SMALL BODY PIECE THAT RUNS ON TOP OF THE BUMPER, THERE ARE THREE PLASTIC SCREWS BY THE GRILLE THEN PULL THE BOTTOM UP AND OUT. AND THEN YOU HAVE FULL ACCESS TO THE HEADLIGHT ASSEMBLY. KIND OF A PAIN IN THE BUTT, NOT TOO DIFFICULT ACTUALLY.
To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.