Super glue
Use industrial strength, weatherproof double sided tape.
that depends. does your 325e have a aluminum bumper or a plastic bumper? if it has the aluminum bumper, you should order new bumper shocks for an post face-lift 87 model. post 8/87. the reason? the shocks that fit aluminum bumpers are very long, and if u attach a plastic bumper, it will stick out too far. if the 325e has a plastic bumper, then everything will be as easy as detaching and re-attaching your bumper.
melt the plastic back. use a lighter,,,
If the plastic circle on your 2010 Civic's front bumper is broken, you can use a zip tie or small screw to secure the snap in place. First, align the bumper with the mounting point, then use the zip tie to loop through the hole and around the frame, pulling it tight to hold the bumper securely. Alternatively, a small screw can be used to attach the bumper to the frame at that point. If the damage is extensive, consider replacing the broken part for a more permanent fix.
In order to repair a broken bumber, you should apply an adhesive to the plastic and let it sit. Then use a plastic welder to mold the plastic back together. If it is just a dent in the bumper, you can use heat and hammer to press the pop back out.
To reinstall a plastic rear bumper on a Dodge Avenger, first ensure you have all necessary tools and clips. Align the bumper with the vehicle’s frame and attach any brackets or mounting points, ensuring they fit securely. Press in any clips and screws to hold the bumper in place, and check that it is properly aligned with the body of the car. Finally, test the fit by gently pulling on the bumper to ensure it is securely attached.
To attach a front license plate to a 2005 Bonneville, simply place bolts through the plate and through the bumper holes in the front bumper. If no holes exist, you can use self-tapping screws to create them.
buy a new bumper, remove the old one, and attach the new bumper
I would think plastic cement.ANS 2 - Epoxy or silicone.
Epoxy is the best one.
probably plastic
Drill into the brick and use plastic anchors and screws.