Use industrial strength, weatherproof double sided tape.
To attach a front license plate to a 2005 Bonneville, simply place bolts through the plate and through the bumper holes in the front bumper. If no holes exist, you can use self-tapping screws to create them.
Using a sharpie marker, hold the license plate up the the front bumper and mark the bolt holes on the bumper and then using a drill gently apply pressure and drill through the bumper, be sure there are no wires behind where you are drilling and not to drill in too far, then attach the license plate with two bolts and nuts.
Usually you can get a license plate holder from a dealership that screws on to the front bumper somewhere then you mount the plate to this holder. If you dont have one of these then you will have to attach it to the bumper area using screws, wire, zip ties, or any other creative way to attach it. If using screws I recommend using stainless steel screws so that they wont rust. You can get these at any auto supply store. Good luck.
Try prying the plastic pieces from the bumper. They should jump right out. They are held in by tabs on the plastic housings.
on the bumper?
what bolt is used to attach license plate to 2009 camery
Usually
Remove 1. Bolts retaining license plate lamp to bumper. 2. Socket from license plate lamp. 3. License plate lamp. 4. Bulb from socket. Install or Connect 1. New bulb to socket. 2. Socket to license plate lamp. 3. License plate lamp. 4. Bolts to retain license plate lamp to bumper.
rear bumper of the car
A license must be displayed properly. How you attach it is your choice.
Just as long as it is displayed somewhere else other than the license plate holder on the rear of the car so that it is no t mistaken for the "legal' state plate. Many people attach them somewhere else on the rear of the car or affix them to their rear bumper.
Many states have laws requiring two license plates be displayed on each vehicle, one attached to the front and one attached to the rear. If your car's front bumper is not already equipped with a license plate bracket, you can just drill holes into the plastic bumper (first marking the correct location with a pen poked through the holes in the plate).