The N14 has an automatic tensioner. Either your tensioner or your belts are in need of replacement.
Are they new belts or old belts. If the belts are new they may need to be tightned or a belt tensioner may need to be replaced. If all are new and tight there may be a part that is failing and is sliping cause it very hard for the belts to trun it.
Keep it clean and lightly lubricated on the pillar. Keep belts taut and not twisted
Fan belts are used to turn the fan in an automobile to cool off your radiator, or in a computer to pull cool air into the motor to keep it from overheating.
how do you replace the belts on a l-1011 fan jet
Look for your belts, the water pump is driven by what used to be called fan belts, so there are a series of belts on the side that your water pump is located, so look on each side of your motor for fan belts that is the side that your water pump is located
First of all, they are the same as the fan belts on any other car. The fan belt(s) are the serpentine drive belt(s) that turn your fan and other accessories (like alternator, compressor, power steering) They are often referred to as serpentine belts, drive belts, and accessory drive belts. The are located on the outside of your engine, driven by the main pulley (crankshaft pulley). R. Mesyef
Put the new fan belts around the fan pulleys. Slide the top tensioner pulley upward. Tighten down the tensioner pulley when you have achieved the proper fan belt tension.
Dodge Dynastys dont have Fan Belts... Their fans run on an electric motor.
on what type of vehicle
Bando USA online offers 'belts' for ones automobile. These belts include, but are not limited to, 'serpentine, V-belts, timing belts, rubber belts and fan belts. They also carry belts for transmissions.
modern vehicles like toyota rav4 does not use fan belts they use drive belts . these belts can be one long serpine tile belt or two belts depending on year and make these belts drive alternater water pump crankshaft pull power stering (again depending on year )