0
Do i have to drop the fuel tank to change the fuel pump in a 1997 Monte Carlo?
Wiki User
∙ 9y ago
More than likely yes, you will have to drop the fuel tank. But, to be sure look inside the car just above the fuel tank for an access panel that will allow you to remove the fuel pump without dropping the tank. I do not think you will find one on a 1997 Monte Carlo.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Check filter 1997 Monte Carlo transmission?
have to drop the transmission oil pan for access
Do you have to drop fuel tank on 1997 Monte Carlo 3.1 to replace fuel pump?
yes, unfortunetly
Does the engine have to come out to change the flywheel on a1998 Monte Carlo has 3.8?
No, you need to drop the trans though.
How do you change thermostat 2003 Chevy Monte Carlo?
Remove the water supply hose from the top of your 2003 Chevy Monte Carlo thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out. Drop the new thermostat in and reverse the process.
Is there a access panel for fuel pump on a 2003 Monte Carlo?
no you have to drop the gas tank
How do you change the transmission fluid on a 1995 Chevy Monte Carlo?
drop the oil pan and put in new screen and filter then put the pan the same way you took it off
Where is fuel pump on 97 Monte Carlo z-34?
Its in the fuel tank. Drop the fuel tank .
Were is the tcc solenoid located on the 98 Monte Carlo?
drop the transmission pan in order to get to it. its rigjt up underneath it
Where is the transmission drain for a 2003 Monte Carlo?
There is no drain plug on the tranny, you have to take all the bolts out of the pan and drop the pan.
Where is the fuel pump located in a 2004 Monte Carlo?
The fuel pump is located inside of the gas tank, you must drop the tank to get to it.
1986 Chevy Monte Carlo will not turn over?
battery? starter? voltage drop between the two? Do you have gas? Check for spark.
How do you change the ignition switch in a 1985 Monte Carlo?
You're going to have to unbolt the steering column and drop it down. The ignition switch will be on the top of the column along with your high beam switch. Unbolt the switch then unplug it.
