Light ends when it runs into something that absorbs it.
Until then, it just keeps on going.
A light blue tube is typically used for a prothrombin time (PT) test.
The 2002 Chrysler PT Cruiser brake light lamp is 3157 bulb. See sources and related links below for a picture and more information.
The address of the East Brother Light Station is: 117 Park Pl, Pt Richmond, CA 94801-3922
To reset the 'check engine' light on a 2002 PT Cruiser, you can disconnect the negative battery terminal for about 15 minutes. This will reset the vehicle's computer and clear the light. Alternatively, you can use an OBD-II scanner to read and erase the trouble codes. However, it's important to address any underlying issues that triggered the light before resetting it.
You should never let it go under 1/4 if you drive a pt cruiser!
The engine light on followed by one chime in a PT Cruiser is a notice to the driver that something is wrong in the engine. The chime sounds only to make sure the driver notices the engine light.
The battery light means your battery is low. You should go to a mechanics.
To reset the engine light on a 2005 PT Cruiser, you can use an OBD-II scanner to clear any stored trouble codes. Alternatively, you can disconnect the negative battery terminal for about 15 minutes, which will also reset the engine light. After reconnecting the battery, the light should turn off if the issue has been resolved. However, if the light comes back on, it indicates that there may still be an underlying problem that needs to be addressed.
0000000000000 pt 1
2 pt = 1 qt; 26 pt = 13 qt
A 2002 Chrysler PT Cruiser was not built with any GPS system.
all you have to do is unscrew the bolt that's on the tail light cover and the whole thing will come out. Then you just twist the light fixture to pop them out of the cover. Here is a video on how to do it: http://www.youtube.com/watch?v=HqXs8Uk3pbs