Want this question answered?
It would not be dangerous to leave a light bulb partially unscrewed, however, there is some possibility that it will fall out of the socket. I would advise that if you don't want the bulb to be on, and you don't have a light switch, unscrew the bulb completely and put it away until you need it.
Only if you leave the switch on. But otherwise no it is not dangerous.
It depend on where the switch is located in the circuit.
It should only take one person to switch on a light bulb if it is 6 light bulbs it may take 6 people to switch on a light bulb Der!
A light bulb
the bulb will light up when current flows thru it if the switch is open no flow will take place
A light bulb is dangerous because if leave it on too long it will burn.
Have you tried changing the bulb ? maybe the bulb is bad
Pull the switch and change bulb in rear. 1 for night light and 2nd for fog light indicator.
Say it is a power circuit, a light bulb is bright from the battery, flowing through the wires and the light bulb. There is a switch controling the power that goes through, so if you switched the off switch off, the power will no longer be flowing through(the light bulb wouldn't be bright any longer). Say it is a power circuit, a light bulb is bright from the battery, flowing through the wires and the light bulb. There is a switch controling the power that goes through, so if you switched the off switch off, the power will no longer be flowing through(the light bulb wouldn't be bright any longer).
Not wanting to state the obvious but the wall switch has to be turned on to supply voltage to the outlet. The lamp will need a three way light bulb in the lamp. A three way bulb uses two filaments of different lengths. One element is used for low brightness, the other filament for medium brightness and the high brightness setting uses both filaments in the bulb. If a single filament ordinary light bulb is used in place of a three way light bulb there will be a position on the three way lamp switch where the bulb will not light. Find the position on the lamp where the bulb will light and leave it there. Use the wall switch to turn the lamp off and on through the controlled receptacle.
most common cause is a burned out light bulb, if not the bulb,check fuses and stop light switch