Yes, NikeBauer Supreme One90 Skate Blade holders do brake very easily. They are a new type of plastic that is lighter than the old ones but is not as strong. If you see a pair you will notice that they are clear and they are actually 3/4 of an inch thinner than old skate blade holders.
Remove the entire skate blade holder - screws and all - from the boot, and replace it with a new skate blade holder with skate blade.
Loosen the screw on the side of the blade holder and it comes right out. Simple.
Remove the bolt holding the blade to the left
"Tandem Productions" : Jerry Perenchio and Bud Yorkin .
It is very simple. In the center of the holder when is pulled out as far as it will go, use a srewdriver blade to push down the tab. The cup holder will now pull out.
to get a blade liger easily i'll give you the code 98243511 08FF welcome.....
Buy the holder and blade $24 at a Nissan Dealer. Remove the plastic cap at the base of the washer arm it just pops off. Remove the 8mm nut and pull the whole assembly off, replace the blade holder and reattach the arm back and tighten 8mm nut. Replace plastic cap and you're done.
If it's in good condition, matching blade & scabbard and has a frog with the bluing intact on the blade. Easily 300-400$
go to the crossroads and choose "somewhere". The end reward could be a BoA peice
Because the blade is sharp so it will easily slide through.
A piece of ice will harden it to a solid and a scraper or razor blade will remove it easily.
When cool, use a single edged razor blade held in a holder to shave it off. Can get them in most hardware stores.