rod bearings only fit one way
Rod bearing (short for connecting rod bearing) Is the bearing where the connecting rod is attached to the rotating crankshaft.
If the bearing has not spun or seized, you drop the oil pan, take the rod cap off of the rod and put the new bearing in. The bearing is in two pieces, half in the rod and half in the rod cap. If the bearing has spun, you should remove the crankshaft and either have the rod journal polished or machined for a thicker bearing.
rod bearing Toyota tercel 87
A main bearing gives the crankshaft a smooth surface to spin on, and a rod bearing, provides a surface for the connecting rod to rotate on.
torque for the rod bearing 2000 dodge
The piston includes the piston, rings, rod, rod bearing, and crankshaft bearing.
The main bearings are what supports the crankshaft. The rod bearings go on the rod that the pistions are hooked to. Rod bearings are smaller then the main bearings on all engines.
The rod bearing torque spec from mercruiser is 45 lb there is no spec that i can find for the main bearing caps.
A rod to which a wheel or wheels is attached is an axle.
bearing journal
You cannot fix a rod bearing. Bearings must be replaced. While it is possible to replace a single rod set, a bottom end overhaul might be the way to go. The rational here is that if one bearing is bad, how far off are the others? In addition, if crank shaft journal service is necessary, the machine shop will supply that correct bearing size after machining .
Rod bearing torque on the 97 2.2 is 38ft lb's Main's are 70ft lb's