answersLogoWhite

0


Best Answer

No, you do not need to open the damper.

Example - A gas cook stove is not vented and neither is the oven. Nor were the old gas space heaters (I still use them) your grandparents used. Carbon monoxide is produced by incomplete burning of fuel. Not just the burning of fuel. In fact the EPA states that a correctly operating gas appliance DOES NOT produce unsafe levels of carbon monoxide. If they did, all our grandparents would be dead. I remember sleeping by an old gas space heater turned on high.

Ventless gas logs are sold world wide, if just the burning of the gas produced CM then they would not sell logs that allowed you to close your damper. The bigger concern with these logs is not CM but oxygen depletion. All vent free logs have an oxygen depletion safety on them and not a CM safety. That should tell you something. So relax. If you are concerned, go to Home Depot and buy a CM detector. I think every home with gas appliances should have one in case an appliance gets faulty.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

14y ago

YES!

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you Open damper when using gas fireplace?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is cold air coming in through the gas fireplace?

Your chimney damper is open


What do you do after discovering your gas fireplace flue was closed during use?

I would have a gas applaince service rep examine the fireplace, and insure that no parts were damaged due to high heat- and leave a note for self to remember to open damper next time.


How do you get more heat into a room when using a gas log fireplace?

Check and see if your fireplace has heat vents on the sides or above the firebox, and that they are open.


What is a fireplace flue damper, and how do you open one?

There are many kinds of dampers, depending upon how old the house is and the choice by the masons. Many dampers have a hinge on the rear and a handle that can be pushed or lifted to lift the front and latch it open. Others have a lever designed to move with a knob or chain connected to the damper. Some chimneys have counter-balanced dampers on the top of the chimney that are opened by pulling and latching a chain. A "tilt and slide" damper not only opens with a handle, but also has a movable grating that can be "slid" open and shut using a knob cast into it. If you have a gas log fireplace and can not close your damper by the handle it is very possible that the damper has been disabled or welded open according to the 1991 building code that states that dampers in new gas log fireplaces must be disabled. The only type of damper that is allowable to use in a gas log fireplace is an inflatable damper. If you do not have a gas log fireplace and you cannot open or close your damper it is likely that it has corroded to the point of non-function. The chimney is a very acidy and corrosive environment any metal in it will rust and degrade rapidly over time. Lubricate the damper with a penetrating oil and try to loosen it by hand or call a chimney sweep to come and work on it.


Can ventless natural gas logs be converted to vented gas logs?

yes it can, open damper in fireplace for drafting while gas logs are being used. As far as converting burners, NO. Ventless and vented burners and logs are different in design.


How do you convert a wood burning fireplace into a gas fireplace?

first off you need to turn off the gas then, cap the gas line then remove the gas line and the vent pipes up in the chimney, then remove the insert or gas log, then install damper doors, put on a suitable door to the fireplace, and put a basket in the fireplace to hold the wood The above paragraph assumes that the fireplace was originally a wood burning fireplace that was retrofit to accommodate a gas fireplace insert and in that circumstance the information is accurate. However, if the fireplace was originally designed as a gas appliance it cannot be converted to solid fuel ( wood ).


Can a gas log fireplace be changed over to wood fireplace?

First off you need to turn off the gas and cap the gas line. Next, remove the gas line and the vent pipes up in the chimney. After that, remove the insert or gas log and install damper doors. Then, put on a suitable door to the fireplace. Finally, put a basket in the fireplace to hold the wood.http://wiki.answers.com/How_do_you_convert_a_gas_fireplace_into_a_wood_burning_fireplace#ixzz17W5OFp8M


How much should vent on gas fireplace be open?

to opn the fireplace and to make a resolotion/


Can you convert a wood burning fireplace to a vent-less?

remove burnt coal, replace with seasoned firewood The above will not work! If you've ever seen a coal fireplace you would realize it is MUCH smaller than a wood burning fireplace. It would require major changes, probably not possible. A normal fireplace will burn either coal or wood or a mixture of both. If the size of the logs is controlled then their is no need to adapt the hearth.


Should you close your flue when using a gas fireplace?

No. The flue must be open to allow the carbon monoxide to escape from the house.


The gas fireplace has left a black residue on your ceiling tile and fireplace how do you remove this?

I have a black film on my ceiling and all walls around the house everytime I use my firepace, I do have the flue open. What causes this black residue from my gas fireplace?


Do you loose heat in a gas fireplace when the flue is open?

Is this an insert into a previous wood burning fireplace? Direct vent or vent free? BTUs?