0
Do you have a bad solenoid switch on 1994 Mercury Sable you get a scraping sound when trying to crank it?
Wiki User
∙ 15y ago
No, usually a scraping sound indicates the starter is dragging and needs to be replaced.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
No voltage at starter solenoid replaced ignition switch and starter relay?
Your neutral safety switch-try putting car in neutral and trying it
1995 lumina put new starter and solenoid when turning key trying to crank no clicking can be heard from solenoid switch you can short solenoid manually and it will crank it has no set pattern what is?
Did you put the small solenoid wire on the correct small terminal?
What causes you starter on a riding lawn mower to stay engaged after shutting off the key?
Sounds like a bad ignition switch. It could also be a bad starter solenoid. If you can find the solenoid you can unplug one of the small wires while it is trying to crank over and see if it stops. If it does it is probably the switch. If it doesn't then it is probably the solenoid.
19hp kohler engine on your ryobi riding mower just clicks when trying to start?
Look for loose connections at the battery, starter solenoid, starter and switch. If all connections are good, the starter solenoid probably needs to be replaced.
Why would a '97 Regal LS just go click click when trying to start?
check solenoid switch, starter cable will be hooked to it near battery
Where is the starter solenoid - switch on a Ford Windstar?
After thinking about this a bit it has to be on the starter, which is on the lower left side of the engine. I was trying to confuse this with the starter relay which Ford has long mounted up on the fender and makes things easy to locate starting problems.The solenoid is located inside the starter.
How do you know if the solenoid is bad on a Yamaha raptor ATV?
If your solenoid is bad on your atv raptor it will just click when trying to start it
What else could cause clicking when trying to start 1996 firebird 3 8 v 6 after having replaced starter and solenoid unit?
Weak battery? Loose or corroded battery cable? Bad neutral or clutch safety switch? Bad ignition switch?
Help please my 1987 bronco 2 cranked over and got stuck and just kept trying to crank even when key was out it died after 5 min replaced starter and solenoid yesterday still will not start?
I would suspect the ignition switch has failed. This is the ignition switch not the tumbler assembly that you insert the key in.
Your 1994 wrangler wont start until you hear a clicking in the front somewhere it will turn over but wont start if you keep trying you will eventually hear the click and it will start?
sounds like you have a bad ignition switch or a bad starter solenoid
What would keep your 1999 Lasabra motor not turn over when trying to start even though the battery is fully charged?
Engine seized? Bad starter? Bad starter solenoid? Dirty or loose battery cables? Bad neutral switch?
When trying to start your car and the electricity and everything still works and it doesn't even make a noise as if it were trying to start what is wrong?
Start with the basics. Is the battery fully charged? Are the battery post clean and tight. If you answer yes to both of these and the engine will not turn over and you hear nothing, suspect the starter, starter solenoid, or ignition switch is defective.
