0
Do you have picture of augerbelt for 47 twine hay baler on baler?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What makes the string cut on a hay baler?
A blade cuts the twine as it finishes wrapping
How does a hay baler work?
hay is picked up by a the pickup tines, then pushed perpendicularly by a "fork". it is then compacted into slabs by the plunger and tied with twine by the knotters. the bale then comes out the back of the baler.
How do you thread international 430 hay baler?
Twine comes out of the twine box, through the tensioner, through a couple of ceramic rings then 1 piece of twine through each needle eye. Once through the needle eye it goes back along the chamber floor and tie it off to something sturdy. The baler will thread the twine into the knotters at the first cycle. A common problem on old balers is the needle eyes have grooves warn in them. You should use a round file to file out the groove so the twine has a smooth surface to run over. A rough surface will cut the twine.
How do you time Massey Ferguson Model 12 hay baler knotters?
How do adjust the knotters on #12 Massey Fergurson hay baler
46 international hay baler is knotting twine twice and won't release from bale hook?
if your getting 2 knots... the knotter is going around two times... adjust the cam Hope this helps....
Does anyone make an ATV hay baler?
No.
When was the hay baler invented?
The inventor of the hay bailer was a man named Innes. It was invented in 1936. the hay bailer was not the large round bailer but the small square bailer
Is a round baler or a square baler more expesive for the same amount of hay?
A round bail of hay is cheaper. The cost of a single bail of hay times the amount in a regular round bail is alot more in price. A round baler is more expensive.
Where can one purchase a hay baler?
One can purchase a hay baler from a store which offers farming equipment such as hay balers. They can also be purchased online from general retailers such as eBay, which will usually be second hand.
Who invented the round hay baler?
New Holland
How do you make a hay flake?
How do you make a hay flake??? A hay flake is a section of hay that freely breaks apart from the bale after you cut the twine. Soooo, I uess my answer would be- bale the hay and then cut the twine and remove the flake! Ta Da..... a hay flake is made! ;)
How do you you thread a new holland 310 hay baler?
Place two rolls of twine into the twine chamber, pull the end of the twine from the center of the rolls. Thread the twine from each roll through the loops in the lid of the twine chamber. Each twine should go through the loop on the side of the lid that the roll of twine sits on. The left side through the left loop, the twine on the right side through the right side loop. Run the twine through the two tubes on the left side of the twine chamber. The again, the left through the left side, the right through the right side. Close the lid to the twine chamber. Run the ends of the twine through the porcelian electric insulator fastened to the needle carriage, then the ends of the twine through the eyes of the needles. Again, the twine from the left side through the left needle eye, the end of the twine from the right side through the eye of the right needle. Pull the ends back to the protective pipes surrounding the needles and tie the ends to the pipe. Raise the bale trip lever on the drivers side of the bale chamber so it will trip shortly after you power the baler. You will need a small amount of hay going through the chamber to do this. When the bale trip lever trips, the needles will come up and the knotters will grab the twine and hold it. You are now ready to bale.
