0
You should or at least each wall at the same time. You could pour it in sections as long as the rebar was joining each section. The problem would be at the joints. How to form up a section of the footing with the re bar in place. If the rebar is not tied together, the wall will move and never be what it should be.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is a monolithic pour?
A pour of concrete, all at a single time. Also called a one-pour system. Contrast with two-pour system. At the same time you pour the floor, you are going to pour the perimeter footings. This is called a monolithic pour (or monolithic slab).
What is the average cost of concrete footings per lineal foot?
The average cost of concrete footings per linear foot can vary widely depending on factors such as location, size, and depth of the footing. On average, you can expect to pay around $10 to $20 per linear foot for concrete footings, but this can increase significantly for deeper or larger footings. It is recommended to get quotes from local contractors to get a more accurate estimate for your specific project.
Can concrete set under water?
Yes. Water is actually needed for concrete to set and is vital to the curing process. Concrete will set just fine under water. Depending on your specific application (will all of the pour be under water or will it start under water and finish above the water line) you may need to adjust the initial dryness of the mix as well as take more care in the pour. All of the volume of the concrete that is under water shoudl be poured in continuous fashtion. If you must pour in steps, the start of the next pour must be "in" the old pour so as to not leave a water survice between the pours. This "seam" will tend to stay and produce a weaker stucture.
Difference between mat foundation and isolated footing?
Isolated footings are constructed invidually & Mat foundation is making of mat and connecting all footings with this mat
What is pour card in civil engineering?
In larger concrete projects with a good quality control program, a pour card is a document that describes the location of the concrete being poured, type/specification of concrete being supplied, a signature block by the inspector and/or engineer indicating that the rebar has been inspected in-place and approved, date of pour, serial number of the concrete truck(s) supplying the concrete, sign-off by the inspector indicating on-site tests for slump and air entrainment (if required) have been completed. Temperature, weather and ticket info from the concrete batch plant/delivery truck are also recorded. The contractor's quality assurance manager will typically keep all the pour cards for a project on file, especially in the even that subsequent testing indicates substandard concrete was installed.
How do you make cement or concrete?
cement/ concrete is made with water, cement mixture and sand. After all of this is added to the right amount, you mix, mix, mix!! Then bofore it drys, pour it ontop the location desired
Concrete Landscape ?
form_title=Concrete Landscape form_header=Is your driveway wide enough? Does your patio extend far enough? Would you like steps that incline? Concrete landscape services can resolve any of these problems for you. Where would you like concrete installed? (Check all that apply)= [] Walkway [] Driveway [] Patio [] Pool Deck [] Steps [] Footings/Curbs [] Mow Strips [] Other What type of service will you need?= () Small Repair () New Construction () Reconstruction Are you interested in lighted borders?= () Yes () No
A concrete foundation that is 24 wide and 36 deep at all points how many cubic yards of concrete are necessary to pour the foundation for the back wall which is 30' in lenght?
One cubic yard every 4.5 linear feet
Self Leveling Concrete Is All About Timing?
Self leveling concrete can be a godsend for folks who are suffering from the effects of uneven floors. Over time, water, weight and even the effects of gravity can make the smoothest concrete finishes inconsistent. Self leveling concrete can often remedy an uneven situation in an afternoon's time, but one important tactic needs to be employed. If the pour is not feathered the finished product will likely have visible edges, which is not a good thing. Keep a close eye on the drying process, stepping in about 15 minutes after the initial pour to feather any edges into smooth surfaces.
How long to mix concrete?
Once all ingredients are thoroughly wet (no "streaks" of dry cement) and the "slump" is correct, it is fully mixed.
What is 'Un pour tous tous pour un' when translated from French to English?
Un pour tous, tous pour un in French means "one for all, all for one" in English.
How do you install a skimmer in an in-ground pool that is 20 years old?
First of all you cut the concrete 2 paralell cuts from pool edge toward the pool equipment, jack hammer out concrete remove old skimmer and coping , plaster, etc, trench out from skimmer location to exist skimmer/drain line,set new skimmer in place plumbin to old skimmer line pour concrete around base of skimmer to set in place, wrap 1/2" rebar drilled and epoxyed into exist pool gunite, build form around skimmer and rebar, pour form with rapid set mortar, pour final layer of finish concrete, replace coping repair plaster and voila you r done
