Yes you need to remove the subframe to remove the gearbox on elantra. the motor must be supported at the top before u remove the subframe.
remove the nearside driveshaft & and just pull the box asside thus giving u plenty of room to renew the clutch with it sitting on the subframe. hope this helps. remove the nearside driveshaft & and just pull the box asside thus giving u plenty of room to renew the clutch with it sitting on the subframe. hope this helps.
Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.
remove the complete dashboard and then replace it
go to 99intrigue.shutterfly.com/compressor. Get clutch remover and installer. Get feeler gauge. Remove serpentine belt with 1/2" breaker bar. Measure air gap in clutch. Remove shaft nut. Remove clutch with remover. Remove outer snap ring. Remove pulley with pry bars or remover. Remove clutch coil with pry bars or remover. Replace new coil and pulley. Replace snap ring. Replace clutch, maintaining air gap. Reinstall nut. Reinstall belt.
you will have to remove the transmission. once you have the tranny off you can remove and replace the clutch...if you buy a new clutch specific directions will come with it...too long to write here.
Remove it and replace it.
To replace the AC clutch discharge the freon, remove the clips, and remove the screws under the bumper. Remove the driver side headlight, and bolts.
Support the engine and transaxle from above using a support bar. Raise the vehicle on a hoist lift. Remove the front lower control arms and swaybar bushings from the subframe. Support the subframe with tall jackstands. Unbolt the engine and trans mounts from the subframe. Remove and clips or brackets for such things as oil coolers or wiring attached to the subframe. Remove the susbframe mounting bolts, then lower the subframe from the car. Reverse the procedure. Get a wheel alignment. Be sure to tell whoever is doing it that you replaced the subframe as this information is critical for the alignment to come out the way it should.
no
Remove the Subframe. Subframe should be removed but it can be done by lowering Subframe down. I recommend removing the Subframe. Do not pry in oil pan with a screwdriver, get a rubber mallet, it is glued in place.
How to remove fan clutch on 2003 ford explorer
You will a lot of special tools as well.. Remove the A/C compressor Remove the A/C clutch disc and hub retaining bolt. Remove the bolt. Remove the A/C clutch disc and hub spacers. Remove the pulley snap ring. Remove the A/C clutch pulley. Remove the A/C clutch field coil.