go to 99intrigue.shutterfly.com/compressor. Get clutch remover and installer. Get feeler gauge. Remove serpentine belt with 1/2" breaker bar. Measure air gap in clutch. Remove shaft nut. Remove clutch with remover. Remove outer snap ring. Remove pulley with pry bars or remover. Remove clutch coil with pry bars or remover. Replace new coil and pulley. Replace snap ring. Replace clutch, maintaining air gap. Reinstall nut. Reinstall belt.
You need a Z7 Clutch puller.
I am having the same problem. Brought it to an AC specialist and they told me it was my heating/AC panel switch that was going bad. The clutch would not stay engaged because the AC on/off switch was bad.
What exactly do you want to know about "Air conditioning clutch on a 94 ford aerostar van?" How to replace? What engine do you have, etc.?
it will most likely be easier to just replace the pump all at once
To replace the air conditioning clutch on a 2002 Suzuki XL7, first disconnect the battery and remove the serpentine belt. Then, access the A/C compressor by removing any necessary components for clearance. Use a clutch puller to remove the old clutch, install the new clutch, and ensure proper alignment. Finally, reassemble everything and reconnect the battery, testing the A/C system for proper function.
You need a Z7 clutch puller. There is not a lot of info on it being a Z7. There was a lot of trial and error on my part when I did this. They are not that much. You can get them at Oreillys.
how do you oheck air conditioning clutch coil to see if it is overlouding alternator
There is a special tool that will pull the clutch assembly off of the compressor, available at your local parts store!
1. You have a bad compressor or. 2. You have bad compressor clutch or. 3. You have electrical issues or. 4. You have a bad drier and expansion block.
To replace the clutch master cylinder on a 2002 Oldsmobile Alero, first, disconnect the negative battery cable and remove the clutch fluid reservoir cap. Then, remove the cotter pin and clevis pin from the clutch pedal to detach the pushrod. Next, disconnect the fluid lines from the master cylinder and unbolt the master cylinder from the firewall. Install the new master cylinder by reversing these steps, ensuring all connections are secure and bleeding the system to remove air bubbles afterward.
To remove the TCC (Torque Converter Clutch) solenoid on a 1998 Oldsmobile Intrigue, first ensure the vehicle is safely elevated and supported. Disconnect the battery, then locate the transmission, where the solenoid is typically mounted. Remove any necessary components for access, such as the transmission pan or valve body, and then disconnect the electrical connector and unscrew the solenoid from its mounting. Finally, replace the solenoid with a new one, reassemble the components, and reconnect the battery.
The life span and overall maintenance of the air conditioning clutch can have a lot of impact on the life and efficiency of the vehicle's entire air conditioning system. It is important to understand how to inspect and change your vehicle's air conditioning clutch.. So i suggest you ask some advice from professionals or go to the nearest center that offers 24/7 Air con emergency services.