answersLogoWhite

0

Yes you need to remove the subframe to remove the gearbox on elantra. the motor must be supported at the top before u remove the subframe.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you replace the clutch on a Peugeot 806?

remove the nearside driveshaft & and just pull the box asside thus giving u plenty of room to renew the clutch with it sitting on the subframe. hope this helps. remove the nearside driveshaft & and just pull the box asside thus giving u plenty of room to renew the clutch with it sitting on the subframe. hope this helps.


Do you drop the subframe to do a clutch on vauxhall Astra 1.4 16valve 2003?

Yes, to replace the clutch on a 2003 Vauxhall Astra 1.4 16V, it is generally necessary to drop the subframe. This allows for better access to the transmission, making it easier to remove and replace the clutch assembly. However, specific procedures can vary, so it's always a good idea to consult a repair manual or guide for detailed instructions.


How do you remove the clutch pedal switch on a 2003 Hyundai elantra?

To remove the clutch pedal switch on a 2003 Hyundai Elantra, first, ensure the vehicle is in gear and the ignition is off for safety. Locate the switch mounted on the clutch pedal assembly, typically near the top of the pedal. Disconnect the electrical connector by pressing the tab and pulling it off, then remove the switch by unscrewing it or twisting it counterclockwise, depending on the design. Finally, replace it with a new switch by reversing the steps.


How do you replace a clutch in a 1995 s10?

Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.


How do you remove passenger airbag for 2000 Hyundai Elantra?

remove the complete dashboard and then replace it


How do you replace air conditioning clutch on 2002 Oldsmobile Intrigue?

go to 99intrigue.shutterfly.com/compressor. Get clutch remover and installer. Get feeler gauge. Remove serpentine belt with 1/2" breaker bar. Measure air gap in clutch. Remove shaft nut. Remove clutch with remover. Remove outer snap ring. Remove pulley with pry bars or remover. Remove clutch coil with pry bars or remover. Replace new coil and pulley. Replace snap ring. Replace clutch, maintaining air gap. Reinstall nut. Reinstall belt.


How do you replace the clutch for a 1993 Mitsubishi Eclipse?

you will have to remove the transmission. once you have the tranny off you can remove and replace the clutch...if you buy a new clutch specific directions will come with it...too long to write here.


How do you replace rear sub frame bushes on 2002 laguna?

To replace the rear subframe bushes on a 2002 Renault Laguna, first, securely raise the vehicle and remove the rear wheels. Then, support the rear subframe with a jack and undo the bolts securing the subframe to the chassis. Remove the old bushes using a press or suitable tools, and then install the new bushes in the subframe. Finally, reassemble everything by reversing the removal process, ensuring all bolts are torqued to the manufacturer's specifications.


How do you change a clutch on a Kia Spectra?

Remove it and replace it.


How do you replace the AC clutch on a 2002 Honda Civic?

To replace the AC clutch discharge the freon, remove the clips, and remove the screws under the bumper. Remove the driver side headlight, and bolts.


How do you replace the sub-frame on a 1994 Oldsmobile cutlass supreme?

Support the engine and transaxle from above using a support bar. Raise the vehicle on a hoist lift. Remove the front lower control arms and swaybar bushings from the subframe. Support the subframe with tall jackstands. Unbolt the engine and trans mounts from the subframe. Remove and clips or brackets for such things as oil coolers or wiring attached to the subframe. Remove the susbframe mounting bolts, then lower the subframe from the car. Reverse the procedure. Get a wheel alignment. Be sure to tell whoever is doing it that you replaced the subframe as this information is critical for the alignment to come out the way it should.


Do you have to remove the engine to replace clutch and flywheel on VW T5?

no