Sorry Yes You Do.
How do you remove calipers from a 1987 thunderbird? Like where do I start?
Remove fuel tank for access
Remove your idler pulley first. it is the pulley right next to the alternator.
yes, you even have to remove some a/c components wich requires draining you freon unfortunately
Follow the top radiator hose back to the engine. This is where the thermostat is. Remove the 2 bolts and there it is.
its in the gas tank!!!
It was a 1987 Ford Thunderbird
How do you replace the trunk drain hoses on a 1965 thunderbird.
you might be able to just go through the back of the glovebox to get to the heater core
middle of car under passenger side
According to my Chilton's Auto Repair Manual : For a 1987 Ford Thunderbird , 3.8 liter V6 : With engine oil filter change : ( 5.0 U.S. quarts )
u have to grind the hinges
On my Taurus 3.0 engine, I used a wrench on the pulley bolt, and a pry bar to remove tension, allowing me to remove the belt. Then I used a star pattern socket to remove the nut.
When i bought my thunderbird the key to the ignition didnt fit the door locks so i had to replace the locks. That might be the best answer. :]
Remove the water supply hoses from your 1987 Ford E1 50 heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
go check in iraq, you commie. comprendo?
Dont repair...just replace it for your safety!
Ford Thunderbird was created in 1955.
No, replace the converter with a new one. Anything else is illegal.
remove the attaching nuts, and with a ball joint removal tool, remove old link. Then install new link, and torque new nuts to specs.
Get in the back seat and grab the rear brake lite and pull the cover toward you. Bulbs are then remove able.
drain remove fan and shroud undo top and bottom hoses and remove about 4 bolts.
If you are referring to the inertia switch, it is in the trunk.