answersLogoWhite

0


Best Answer

No just the rocket cover

User Avatar

Wiki User

โˆ™ 2010-09-13 04:10:05
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Do you have to remove the head to set tappets on a 1992 Ford Laser 1.3?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat on a Ford Laser 1992?

this was not helpful for me


How do you remove the rotors on a 1992 ford aerostar?

How do you remove the rotors on a 1992 ford aerostar?"


How do you remove ignition switch from 1992 Ford Explorer?

Type your answer here... How do you remove ignition switch from 1992 ford explorer?


How do you remove the alternator from a 96 KJ Ford Laser?

You have to remove the brake master cylinder and remove alternator through there.


Can you remove the tappets on a40 l ford explorer without removing the head?

If you are refering to the 4.0 liter s.o.h.c.,which I think you are. It does not have (tappets) lifters. Its a single overhead cam engine.(no pushrods or lifters)The values are opened directly by the cam.


A 1992 Ford Laser gl how far is the toqure converter seal ment to be in?

flush with housing


What is a lazy muscle car?

a ford laser a ford laser


How do you remove front shocks from a pan Ford Laser?

call me i have a book on it... 814-661-2865


How do you replace a Ford Laser 1989 fan belt?

remove the old belt and remove your trouser's belt off and put into the fan


How do you remove rear seat from a 1989 Ford Laser 4 door?

To remove the rear seat from a 1989 Ford Laser 4 door car, first remove the bolts anchoring the rear seat to the floor of the vehicle. Then, lift the bottom portion of the seat from the car. Then, remove the internal bolts from the hatchback or trunk of the car to remove the seat back.


How do you remove the heater core on a 1992 Ford Explorer?

specs on how to replace a heatercore on a 1993 ford explorer


Do Ford Laser 1.6 have adjustable tappets?

Yes. must be done hot. Valve stem to rocker : Inlet .30mm Exhaust .30mm Camshaft to rocker: Inlet .19mm Exhaust .19mm EFI have hydraulic tappits

People also asked