answersLogoWhite

0


Best Answer

If you are only replacing the bulb, it can be accessed on the back of the high mount housing in the trunk area.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you have to remove the rear seat to change the high mount stop bulb on a 1993 Buick Park Ave?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the front transmission mount on a 1993 buick lesabre?

It has 2 nuts in the bottom of the frame and three bolts on the transmission case


How do you change the alternator on a 1993 civic ex without removing the motor?

remove tire. remove bottom mount. pullout through bottom.


How do you reset change oil soon light on 1993 Buick park avenue?

= How do you reset change oil soon light on 1993 buick park avenue? =


How do you remove fuel pump on 1993 Buick roadmaster?

Remove the fuel tank to gain access to it.


How do you remove a starter from a 1993 Buick Roadmaster estate wagon?

Remove the crossmember and drop it out the bottom no problem.


How do you open hood release cable on 1993 Buick roadmaster?

Remove the grill


How do you bypass the factory alarm on a 1993 Buick Park AV?

The easiest way to disable your 1993 Buick factory alarm is to remove the alarm fuse. The alarm fuse can be found in the fuse box.


How do you remove the brake rotors on a 1993 Buick Century?

Remove the tire, brake caliber and the rotor should side off the hub.


How do you raise motor out of a 1993 Ford Festiva to change the timing belt and how to change the timing belt?

remove top engine mount and cut off metal lug that stops engine from lowering enough to remove harmonic balancer. Then engine lowers enough.


How Do You Replace a Fuel Pump on a 1993 Buick LeSabre?

Located in fuel tank - remove tank to access


How do you remove the door speaker in a 1993 buick park avenue?

start by taking the door panel off ....


How do you change the alternator on a 1993 Buick regal custom?

you loosen the bolts on the opposite sides of it. then, you change the alternater, and tighten the bolts.