Want this question answered?
Remove each of the coils then remove and replace the plugs
Disconnect the battery. Remove the ignition coils. Remove the ignition control module that was under the coils, and replace it.
The spring has been stretched. When the coils are squeezed together then the spring has been compressed.
remove the intake up to the throttle body. after that you should be able to see the coils on the drivers side of the engine. remove the bolt and replace. don't mix the ignition wires.
In a spring, squeezing some coils together more tightly causes the nearby coils to be more spread apart
Remove the 4 allenhead bolts from the v-6 3000 emblem in center of the valve cover. Lift off { Tshapped v-6} 3000 emblem. Remove spark coils located beneath. Remove plugs under spark coils. As far as I know you must replace coils and wires together. However you can replace just the plugs.
In a spring, squeezing some coils together more tightly causes the nearby coils to be more spread apart. So this is how it increases.
In a spring, squeezing some coils together more tightly causes the nearby coils to be more spread apart. So this is how it increases.
First you remove the plastic engine cover on top of the valve cover. Then you remove the wires from each of the three coils, then you remove the bolt holding each coil and remove coil. Down in that hole is the spark plug, remove with socket and replace.
under the plastic cover on top of the engine, you will need a torx fitting to remove the cover, then the coils are on top and spark plugs below the coils, very easy to replace, coils are just 1 10mm bolt each
check coils function properly. Check earthing points. Check power to the coils.
by pressing the spring down witch coils the spring.