0
Do you have to take the engine out to replace the rear main seal on a 1998 subaru legacy?
Wiki User
∙ 14y ago
No you can access the rear main seal by removing the Transmission, flywheel etc
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the knock sensor location on a 1998 subaru legacy?
In a 1998 Subaru Legacy, the knock sensor is located on the top of the engine block and to the left of the engine. More specifically, it is under the left rear intake manifold runner.
What is the correct octane fuel for a 1998 subaru legacy?
The correct octane fuel for a 1998 Subaru Legacy is RON98. This is the right octane to be used based on this car's engine for best performance.
How much will it cost to replace subaru legacy inner tie rods?
how much will a inner tie rod cost with an allingment about? Subaru Legacy 1998. And does this affect the way your car drives?
Where is the catalytic converter on a 1998 subaru legacy?
It's part of the exhaust pipe, between the muffler and the engine.
How do you replace the clutch slave cylinder on a 1998 subaru legacy?
remove the old one and install a new one.
What is Spark plug gap for Subaru 98 2.5 l?
The spark plug gap for a 1998 Subaru Impreza/Legacy with the 2.5L DOHC engine is .044".
How many qurts of oil does a 1998 subaru ouback legacy 2.5 engine take?
My 1997 legacy gt sedan takes 4.8 quarts of oil.
Is a 1997 subaru legacy outback transmission the same as an 1998 subaru sus?
It should be.
Did the 1998 Subaru Legacy GLS come with a fob for the central locking and if so where can you get one?
I have a 1998 Legacy Outback LTD and have replace the fob sucessfully with one purchased on e-bay. Programming instuctions are available as well.
What oil weight for a 1998 Subaru legacy outback?
5w30
Replace engine air filter on a 1998 Subaru Forester?
Yes, at the age of this vehicle you probably should.
Where is the fuel pump on a 1998 subaru legacy?
It is inside the fuel tank.
