answersLogoWhite

0


Best Answer

It takes special equipment and line to make brake line.

If someone in your area has this equipment they can make new ones. If not you will have to buy them.

depending on the year make and model you might be able to purchase factory brake lines pre bent . from the dealer

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you have to use the braided rear brake lines or can you make them?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Diagram of brake lines on 1993 topaz?

need diagram of rear brake lines for 1993 mercury topaz


What diameter are my brake lines on my s10 pick up 1995?

Front brake lines, 3/16". Front to rear, 1/4". Rear, 3/16".


Replacing rear brake lines 1999 Chevy blazer ls 4x4?

The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.


What brake line goes to the driver side rear wheel on 91 Chevy cavalier?

Rear brake lines leave Master cylinder as one and are junctioned at the rear of the vehicle


What is the size of rear brake lines on a 1998 Mercury Sable?

3/16


How do you fix a brake line on a 92 crown Victoria lx?

If you are talking about the steel brake lines, most likely the rear lines, then replace both from front to back.


Which brake line feeds to the drivers side rear on a 1993 ford thunderbird lx?

In most cases the front section of the master cylinder Rear brake lines are "T'd" at the center of the rear axle


Your brakes feel light and there is brake fluid leaking from rear disk brake on a peugeot 106 1994?

change the wheel cylinders or the brake lines


What size brake lines on the rear Chevy Cheyenne?

about 2 foot on each side


What is the cause of a brake rear axle imbalance?

one could be the lines need bleeding


Got a question but a 94 Toyota Camry brakes went out and replaced a master cylinder in the rear why is it still getting air in the brake lines?

When you work on brake system you want to remember to bleed the brake lines.


What aRe the black hoses underneath rear of car?

Fuel filler neck and vent, evaporative emission lines, brake lines, an axle vent, or rear washer hoses. What type of car is it and what size are the lines?