0
What else can I help you with?
How an engine prepared for starting?
Depends on the engine. A fuel injected engine will run the fuel pump to prime the engine. A diesel engine might have glow plugs run prior to starting. Some older heavy equipment engines had a gasoline pony engine to get the crankshaft turning prior to starting the engine.
What is the carburetor?
It's a device that mixes fuel and air prior to the engine pulling the mixture into the cylinders for combustion. The carburetor also allows the vehicle operator to control the power/speed of the engine by controlling the amount of air that is allowed into the engine.
Why do you heat engine prior to starting it?
Things work faster and better when heated, with a few exceptions.
Is an engine likely to be ok if the spark plugs have been left out of it. It has seen no rain and has set for about 1 year.?
Put a few drops of mystery oil into cylinders prior to installing plugs
Can you replace a 86 2.9 with 98 3.0 in a ranger?
Yes, but you must replace the blinker fluid prior to starting the replacement engine.
If your boat has a power ventilation system how long should you turn it on for after fueling and prior to starting the engine?
Four minutes is the recommended time.
How do you check the oil on a car?
With engine cold (prior to first starting in the morning) and parked on level ground - remove dipstick and check oil level as shown
Where is the spark plug location for a 2001 Kia sprtage?
AFAIK kia Sportage doesn't have any sparkplug at all since its a diesel. probably your asking for the glow plug which also heats the engine prior to starting the engine.
Can you give me a sentence for the word prior?
He told me about their divorce prior to having discussed it with his wife.
What should you do prior to starting nasogastric feeding?
The exact procedure depends on your level of licensure, education, and competence. You should become properly trained prior to starting an NG tube feeding.
When attaching a lifting eye to an engine prior to removing the engine with an engine hoist how far must a 10 mm bolt be threaded into the engine?
20mm
How do you prime the pump?
Fill it with water from a bucket or hose prior to starting it.
