answersLogoWhite

0

Things work faster and better when heated, with a few exceptions.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Do you lubricate engine cylinders prior to starting an old engine?

yes


How an engine prepared for starting?

Depends on the engine. A fuel injected engine will run the fuel pump to prime the engine. A diesel engine might have glow plugs run prior to starting. Some older heavy equipment engines had a gasoline pony engine to get the crankshaft turning prior to starting the engine.


What is the carburetor heat position for starting a aircraft engine?

gas


Can you replace a 86 2.9 with 98 3.0 in a ranger?

Yes, but you must replace the blinker fluid prior to starting the replacement engine.


If your boat has a power ventilation system how long should you turn it on for after fueling and prior to starting the engine?

Four minutes is the recommended time.


What do glow plugs do in a diesel engine?

They preheat the air in the cylinder to make starting easier. they actually heat the diesel fuel to make starting easier


What is the difference between carnot heat engine and a heat engine?

difference schematic diagram between carnot heat engine and heat engine


How do you check the oil on a car?

With engine cold (prior to first starting in the morning) and parked on level ground - remove dipstick and check oil level as shown


Where is the spark plug location for a 2001 Kia sprtage?

AFAIK kia Sportage doesn't have any sparkplug at all since its a diesel. probably your asking for the glow plug which also heats the engine prior to starting the engine.


What is a glow plug?

Glo plugs are basically a heater in the top of each cylinder that heat up for the better starting of a diesel engine.


What are the different ways to start a diesel engine?

One of the ways of starting a diesel engine is turning the key to stat position without turning the engine on. The second step is to wait for the glow plugs to heat up.


The amount of work done by heat engine equals the amount of what?

The amount of work done by a heat engine equals the difference between the heat input and the heat output of the engine. This is known as the heat engine's thermal efficiency.