Want this question answered?
How do you install an after market stereo in a 1989 acura legend?
Go to Wal Mart or Autozone and buy the harness adapter kit. Wire the connector to your stereo, and then plug the connector in the factory stereo harness and you are done. Easiest and cleanest way to install aftermarket stereos. Cost less than $20. or........ go to www.12volt.com.....right there hey have the wiring diagrams for almost n e thing
Attached the wiring harness and the antenna cable to the back of your stereo. Slide the stereo into the stereo slot. Tighten the stereo with the stereo retaining screws.
Go to your local Canadian tire and buy a plug that goes from stereo harness to your stock harness!
Connect the wiring harness to the back of your 1995 Buick LeSabre stereo. Secure the stereo with the stereo retaining screws.
Begin by removing the decorative cover to your stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.
Remove the retaining cover from your stereo. Remove the stereo retaining bolts. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.
MAYBE WAL-MART IF NOT A STEREO INSTALL SHOP
They all should be attached to a wiring harness un less your install a radio then not all wires will be attached to the after market harness in most cases the wires that are not attached can be used to hook up subwoofers
# you can buy a after market wire plug from walmart that plug into factory harness plus a universal steore insulation from walmart
you need to pop out the frame and unscrew the radio. You will need a wiring harness for an after market stereo.
It is pretty easy, go to the stereo shop and buy the install kit as well as the wiring harness adapter for your vehicle. All you have to do is follow the directions and match up the wires of the new stereo wire harness with the adapter you have purchased. Remove the old stereo, install the mounting hardware. It should plug right in to the factory wire harness and snap in place.