0
yes, u need to use the bleeder valve or u can gravity bleed it
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you adjust the clutch pedal on a 2000 Nissan Frontier with 90000 miles?
theres no adjustment. need to replace the clutch.or if clutch is new you need to bleed the slave cilinder by the transmission
Do you have to drop a gearbox on a 1.8i cavalier expression to do a clutch?
The transmission must be removed to install a new clutch.The transmission must be removed to install a new clutch.
How do you replace clutch master cylinder on 94 civic cx?
answer remove 2 clutch pedal bolts and pin,remove the reservoir unscrew the fluid pipe,install the new one then bleed it very well
How to bleed the clutch in a 1995 Saturn?
You don't. The part (if it contains air) has to be replaced. If it's new.. it doesn't need bleeding.
The clutch pedal on your 89 240sx sticks to the floor it has a new clutch what do you do?
Bleed the slave cyl. It probebly has air in the line or no fluid.
How do you replace a clutch in a 1995 s10?
Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.
What do I do after installing new clutch 2005 corolla xrs the clutch pedal seems super free to push in also having a rough time moving in and out of gears as if misaligned?
Bleed the clutch line that runs from the clutch master cylinder to the slave cylinder utilizing the bleed valve on the slave cylinder.
How to replace a master cylinder on a 1994 Honda Accord?
answerremove 2 bolts and a cotter pin in the pedal,remove reservoir,unscrew fluid pipe,install new one,bleed clutch very well
How do you change 2000 Honda CR-V master clutch cylinder?
answerremove 2 bolts and a cotter pin in the pedal,remove reservoir,unscrew fluid pipe,remove bolts for slave unscrew the fluid pipe,install new ones,bleed clutch very nicelly
Do you need to bleed all 4 brakes after I install new rotors and front pads?
no, it's not necessary unless your pedal fades or it's spongy.
How do you adjust the clutch on a 1988 Nissan pickup?
Its hydraulic ,you cant,check your slave cylinder to see if its leaking,its located thru a rubber cover on side of transmission,if leaking replace and bleed,also check clutch master cylinder,if not leaking,then you might need a new clutch kit.
How do you install a transmission clutch on a f250 diesel 7.3 l?
not a job for the non mechanical person first you chock wheels on vehicle next remove driveshaft disconect clutch cylander fluid line you then need to use a jack to support rear of engine remove gearbox from vehicle usually need a transmission jack to do this next u then remove clutch from flywheel on rear of engine then check flywheel for cracks as this may need replacing as well if flywheel is good, u then install new cluch, u will need an aligning tool to lign up clutch with flywheel and to support while installing bolts,be sure to tighten bolts in proper sequence now is also a good time to replace clutch slave cylander then you need to bleed the cylanders replace drive saft also a good time to check and replace U joints if needed
