0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you repair a head gasket 1994 Chevy G20 van?
You will need to remove the cylinder head from your 1994 Chevy. Remove the head gasket and clean the surface. Put the new head gasket on and put the cylinder head back to its original position.
How do you replace an Air compressor gasket?
There are many gaskets on any machine. Is this an electric compressor? Once you find what gasket it is specifically, you simply need to remove that part, and add a new gasket, then put the part back on...
Where is the thermostat located on a 96 Chevy Lumina 3.1?
the location of the thermostat is under the throttle body.before you put it back on you need to buy some gasket sealer or a gasket for the thermostat
How do you replace a starter for a 1990 Buick Regal Gran Sport?
There are several wires that must be removed from the existing starter before it can be replaced. The wires need to be taped and labeled so that they can be put correctly back on the new starter. The old starter needs two bolts to be taken out to put the starter in.
I have a 96 dodge intre. 3.3. i just replaced the starter but did not put the gasket back on it. i dnt think the car is grouded properly it will turn over but not start.. what is wrong?
You may need to change your sparkplugs, since it sounds like it is turning over but not firing up. Gasket shouldn't matter if yourt not running it right now. Just starting it and idling. But before you go anywhere get a gasket
Do ya need to set cam timing on daewoo matiz 800cc when put new gasket on head?
In what sequence does it go back
How do i replace 97 surburban starter exactly?
Disconnect the positive battery cable and then take out the starter bolts and remove the wires/ then put the wires onto the new starter, put the stater back on and then put the battery cable back on.
How do you put a starter relay on a 1997 ford expedition?
The starter relay is inside the starter. You will need to replace the starter.
How do you change a head on a 1990 geo storm?
buy a head gasket remove the bolts,put the head gasket on the block line the new head up with the bolt holes put the bolts back in and put the cams back in time.
How do you hot wire 2002 RSX?
lmfao. why do you need to do that? you need to take apart the whole steering column. Take off the case, take off the starter, separate the starter with the thing on the back of the starter. Take the part you separated and put a screw driver inside of it and turn.
How do you change a starter on a 92 Toyota Corolla?
disconnect the battery cables, remove bolts/nuts, remove wire, pull starter off, bingo~! put the new starter in, put the bolts/nuts back on, put the wire back on, hook the battery cables back up, bingo~! fire it up!!!
Do you need to put silecon on a reusable gasket?
If it has an o ring you shouldn't have to
