answersLogoWhite
Ask
Fuel Filters

Do you need to release the pressure in the fuel lines to replace the fuel filter in a 1991 Geo Tracker?

515253
Answer

Top Answer
User Avatar
Wiki User
2015-07-15 21:19:19
2015-07-15 21:19:19

yes, just take off the gas cap while you change the filter. dont wurry, some gas will grain out while you do this. (a few ozs.)

1
0

Related Questions

User Avatar

First you need to release gas pressure in the high pressure gas line, disconnect the pump harness. Remove the bolts. After that remove carefully the pump from the tank, make sure that there is no dust around. Replace the filter, reinstall.

User Avatar

I would immediately check the oil level. If you find that it is not low of oil, immediately replace the filter with a new name brand filter. AC/Delco would be my choice in this vehicle. If that does not help, replace the oil pressure sending unit.

User Avatar

You release it by taking off the fuel filter. Be sure the ignition key is off. About a half cup of fuel will spill.... more if you encounter a siphoning effect.

User Avatar

remove fuel pump fuse. then start engine it will stall when fuel runs out change filter then replace fuse.

User Avatar

auto-drain the fluid replace the filter and refill with new AFT (automatic transmission fluid) mannul-drain and replace fluid


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.