0
Do you need to replace the whole ignition lock assembly when the electrical portion of the ignition switch goes bad in a 1993 Honda Civic LX Auto Trans?
Wiki User
∙ 16y ago
If the lock cylinder is faulty, the entire steering column lock assembly will have to be replaced. reference " Haynes Repair Manual"
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the ignition coil on a chrysler Sebring with the 2.5?
You have to replace the distributor assembly.You have to replace the distributor assembly.
Why is ignition key hot on a 1981 corolla The key will not turn to start. Is it the ignition switch andor the locking barrell assembly.?
replace the ignition swith. replace the ignition swith.
2002 Passat - Fuses all OK but no wiper heater blower or HL headlight power - are there any relays I should check?
Replace the electrical portion of the ignition switch
How do you use electrical in a sentence?
What will you charge me to replace the electrical outlet? The ignition system is based on electrical engineering theories.
What do you do if the key is stuck in your Acura Vigor switch?
Replace your ignition lock assembly.
How do you replace the fog light assembly in 2005 Ford Escape?
Remove the fasteners and electrical connection from behind the assembly and slide the assembly out the front.
How do you remove the Ignition switch assembly on a 1993 Acura Legend?
you have to replace the whole steering column
Why does your ignition turn the wrong way on your 1979 camaro can not get the ignition to turn forward only back. can not start?
Replace the tumbler assembly, it is broken.
How do you replace the ignition switch assembly on a 1990 Chevy half ton truck?
If this has the locking tilt wheel it is better to find a salvage yard and get the entire steering assembly . Can get for around $100. Parts and time for replacing the Ignition assembly if you can do it at all will not be worth the effort.
How do you remove and install a ignition key from a Saturn?
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
How do you replace the ignition 1990 buick custom?
You have an open question as to what you are asking. Are you referring to the key and tumbler assembly or the actual ignition switch meaning the electrical part? If you mean the key and tumbler then you need to have a locksmith do it or a repair shop as the key is coded for your car. If you are referring to the switch then in that case you will need special tools to remove it.
How do you remove the ignition switch cylinder to replace it on a 1971 Chevy truck with no key?
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
