Yes, use exactly what Honda recommends, and you will have to purchase synthetic oil as they do not make conventional oil in SAE 0W-20 weight.
The code varies from car to car. You will need to contact the local Honda dealership to see if they can provide you the code to reset the Pilot's radio.
You need a blub or your brake fluid is low.
90,000 miles is what the dealer told me
Unlike Honda's sister vehicle, the Odyssey, where it's designed to be pulled out without tools, on the Pilot you will need to unbolt the bottoms of the second row seats to remove them.
You can reset the check engine light on a 2005 Honda Pilot by disconnecting the battery for a few minutes. If it comes back on, you need to take it to have it checked or reset by a mechanic.
I needed the code for my radio about a month ago, I called my Honda dealer with my VIN and they gave me the code for the radio.
To replace the speed sensor on a Honda Pilot you first need to research it. There are two speed sensors on the Honda Pilot. One is on the transmission the other is on the left front wheel. To replace the one on the tranny all you do is unscrew it. To change the other you have to remove the wheel, brake caliper and caliper bracket. Then you remove the hub. Then you pull it out.
You don't. The car will engage 4WD automatically when needed. Improve Answer: The car will NOT engage 4WD automatically when needed. You need to manual engage 4WD by yourself. Please read your Honda Pilot manual.
Vehicles vary so you may need to read the owners manual.
The Honda Shadow carburettor adjustment will be done through the setting of the pilot screws.You would also need to do synchronization so as to compete the adjustment.Ê
2WD: on the front tires 4WD: on the front and rear tires but Honda Pilot 4WD is not a full 4WD therefore no need to put chains in rear tires unless you're manual engage 4WD.
To set the clock on a 2011 Honda Pilot, press the middle of the knob that adjusts the clock until you see the part that you need to change, such as the hour. Then, turn the knob until it gets to the correct time. Then, select "exit" to finish.