YES! There IS a difference.
Plumbing dies cut a thread tapered from start to finish at the rate of 3/4" in 12 inches, usually 3/4" of thread length on 1/2" or 3/4" pipe.
Conduit uses the same size thread with all the taper in a very short distance at the pipe-end of the thread so that the thread is straight and a lock-nut or coupling may thread all the way onto the pipe without binding and without the use of a wrench.
I've been doing electrical since 1947, and still at it.
The Old Fat Man
yes i need different symposium name for electrical and electronics engineering
It is true that a cold water pipe will work as a ground but it should not be trusted. If the wiring in a house is older then the introduction of electrical grounding I would have to recommend the instillation of new grounded wiring. Grounding using the plumbing system, past where the cold water pipe enters the house, can present a hazard to plumbers. They can receive electrical shock if they remove a piece of pipe that was part of the groundings pathway. Also, as plumbing codes change they do not take into account electrical need. In many areas of the united states plumbers are using non-metallic piping and fitting. If this is added to your system you will lose your grounding.
You would need to shutdown the power whenever you are working on the electrical service.
This is the electrical code book used in the United States of America. Rules set out for electricians to use, to keep all electrical installations the same for all jurisdictions throughout the country. Different regions will have addendum's additional to the code to cover different regional climates and conditions.
Dear sir i need the jto's electrical previous model papers and answers papers yours faithfully s.sudhakar
for making plumbing pipes and electrical wire among other things.
Electrical training courses may be added to the curriculum. It varies from school to school. Electrical training can help with many plumbing jobs though.
I need to start. School for plumbing
New York State does not license "handymen." The state may require a business license if you are conducting a business, and you may need a plumbing license or electrician's license if you will do plumbing or electrical work.
yes i need different symposium name for electrical and electronics engineering
Electrical engineering is a different field. What you need is criminal justice for a probation officer.
Does the engine turn? It may be an electrical problem You need to diagnose it properly, you may need to let an experienced person look at it
No but you do need to study about plumbing. You can find places where you learn imparticuarly about plumbing.
plumbing is most useful for our home, because we need to make water supply in different part of a home like kitchen, toilet, bathroom etc. To supply the water at required places of a home, we have to install and connect pipeline system that whole process is called plumbing and this overall functionality is done by plumbing professional.
Depends on the siZe of the bathtub and where you want the plumbing to be. And you need to make sure there is electrical outlet for the jets. But if u can fit everything in. Then it u just need the room for that
Not necessarily, depends what and where plumbing work is to be done. Check with local plumbing authority about needing license or not. Sometimes you need license to pull permits to do plumbing work. Plumbers usually have at least a journeyman's license.
You need a permit to build one in most populated areas. You need a permit to run a public pool. You don't need a permit to operate a private home swimming pool.