0
Normally you want to put it in the reserve tank normally attached to the washer fluid unless your system is empty. if you open it directly when the engine is hot it surges out and will burn your hand on the cap. If you do not have a reserve make sure the engine is cold preferably before you do any of your running.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where do you put the radiator fluid in a Chevy 2004 silverado 2500hd?
Pour the coolant in the radiator.
How do you replace radiator coolant Toyota hi-ace?
Pour water/antifreeze at ratio 60/40 into radiator
How do you add coolant to your 2007 Nissan Xterra?
Once the cooling system has had time to depressurize, open the radiator cap and pour your coolant in.
Where do you pour your antifreezecoolent on a 2004 jetta?
Either at top of radiator or through coolant recovery tank
Where do you pour antifreeze into a 2000 Plymouth Grand Voyager?
In the top of the radiator or through the coolant recovery tank
How do you check coolant level on a 2006 Kawasaki Vulcan 2000?
Stand the bike upright and examine the coolant gauge.
How can you make coolant?
One gallon and antifreeze and one gallon of water are needed to make coolant. They are then mixed together in a large bucket and then pour into your vehicles radiator.
How do you change coolant on n16?
Do this when the engine is cold only. First, remove the radiator cap. Then, locate the lower radiator hose. Unfasten this from the radiator. The old coolant will come out. Wait until the coolant has all come out. Then fasten the radiator hose again, make sure it is tight. Pour the new coolant into the radiator. Then, start the engine and let it idle. Pour more coolant into the radiator until it is almost full. Leave a space of 1 cm or so as the hot water will expand in the radiator and needs more space than cold water. Then, replace the radiator cap. Make sure the radiator hoses are not cracked or leaking. Check the coolant every week on older cars, at the same time as you check the engine oil level. Be careful with this, as the pistons will seize in the cylinders if the cooling system runs dry or even partially dry.
How do you replace the coolant on a 2003 duramax?
remove pass side inner fenderwell. On the radiator you will see a drain. Loosen that and coolant will pour out. reinstall drain plug and top off with coolant approximatly 4 gallons.
How do you changing antifreeze on a 1992 Dodge Dakota?
Take off your Radiator cap. Under your radiator you will see a butterfly nut on the right side. Unscrew that nut and all your coolant will pour on out. Replace the nut and refill with a 50/50 mix of coolant.
How do you add coolant to radiator in 1995 Chevy cavalier?
Open the radiator cap and pour coolant in. If you're filling an empty system, you'll want to leave the cap off, and run the engine for 30 minutes or so to 'burp' out any air in the system, then top your coolant off again.
Do you have to drain the engine coolant before replacing a water pump on a 96 cav 2.2 I mean is the coolant going to pore out after I take the pump off?
Most, if not all, the coolant in the radiator reservoir will pour out when you pull the water pump. Drain the radiator and save the coolant (if you plan to re-use it) before removing the water pump.
