The idea is to keep the brake fluid reservoir full during the process.
Pour it into the brake fluid reservoir. It is in front of the brake booster. If you don't know where that is then take it to a service center before you have major problems.
You put the brake fluid inside the brake master cylinder
you put the brake fluid inside the master cylinder
To put brake fluid in a 1997 Ford Explorer, you must locate the brake fluid reservoir. Once you locate it, unscrew the cap, and replenish the brake fluid.
Open brake fluid reservoir for the brakes - make sure it is full of brake fluid - put lid back on reservoir then pump the brakes then hold the brakes on - have someone open the bleed screw on the brakes and let the air and oil out and close it again quickly and repeat until the air bubbles stop in the brake fluid, also checking to make sure you do not run out of brake fluid before you finish bleeding the brakes.
in the brake fluid bottle. >:D
The brake fluid reservoir
Before you add brake fluid, are you SURE you need to add some? Because as brake pads wear, the brake fluid level goes down, but the brake pads need to be replaced then, BEFORE any brake fluid is added. Otherwise, when the brake pads ARE replaced, there will be too much brake fluid in the reservoir, and it will flow out when the pistons are pushed back into it's bore, to make room for the new pads. -Tom.
The brake fluid in a 1992 Ford Escort gets put in the brake fluid reservoir. This is normally located on the master cylinder.
You get brake fluid that will cause tooth decay
you open the cap that says brake fluid, and then you pour it in
You put brake fluid in the brake fluid reservoir on a 1998 Dodge Stratus. This is located on the master cylinder, under the hood, on the driver's side.