Before you add brake fluid, are you SURE you need to add some? Because as brake pads wear, the brake fluid level goes down, but the brake pads need to be replaced then, BEFORE any brake fluid is added. Otherwise, when the brake pads ARE replaced, there will be too much brake fluid in the reservoir, and it will flow out when the pistons are pushed back into it's bore, to make room for the new pads. -Tom.
To add brake fluid to a 1989 Dodge Spirit, locate the brake fluid reservoir, which is typically found near the back of the engine bay on the driver's side, just behind the master cylinder. The reservoir is usually a translucent plastic container with a cap labeled for brake fluid. Ensure the vehicle is on a flat surface, remove the cap, and add the appropriate type of brake fluid until it reaches the recommended level marked on the side of the reservoir. Remember to securely replace the cap after adding fluid.
Near the battery attached to the round brake booster.
Master cylinder. Located on the firewall, driver's side, in front of the brake booster.
Dodge Spirit was created in 1989.
On the firewall, in front of the booster, on top of the master cylinder.
in front of steering wheel in engine compartment ( two small caps on rectangular block )
The brake system uses brake fluid and the trans uses trans fluid.
Mopar ATF+3 or ATF+4 trans fliud Dot 3 brake fluid
Under the hood, under the battery theres the Transmission Dipstick... Just pull it out, take a long like funnel, put it on and fill it up.
The brake fluid reservoir on a 1989 Mazda 626 is on the master cylinder. This is located in the engine compartment on the drivers side.
Above the master cylinder, below the brake fluid reservoir lid.
R-12