No, there is nothing to unplug. You do need to remove the brake master cylinder cap and make sure to keep the fluid level at full during the bleeding procedure. Bleed the brakes in this order. Right Rear, then LR, then RF, and end at the LF.
If you disconnect the ABS module, the system will default to conventional brakes, but the ABS light will be on.
it really dosent matter, just be sure to unplug it before you drive off.
NO you do not have 2 unplug a cell phone b4 answering it
Unplug the tire pressure light cable.
I don't think you have to do anything unless the computer says that it is synchronizing otherwise it shouldn't matter and you can just unplug it.
A 95 pathfinder ignition timing is controlled by computer, but 0 is tdc so -5 is the first mark to the left.
Yes you can. All the harness wires unplug.
unplug battery for 24hrs. and this should clear all code errors and reset computer.
Disconnect the brake lines and wiring harness from it and put the new one in. YOU will need to bleed the brakes after your done. Make sure to disconect the battery of the truck before you unplug the wiring harness
under dash 4x4 gold box left side steering wheel.... hard to get out but you can unplug it
To unplug a toilet, consider using long gloves to pull out anything blocking the inside and then use the plunger to help the water flow again.
If you are cleaning anything electrical ALWAYS UNPLUG IT...