Yes. I use them to switch from Fastrack to the old style to run across my Rail King bridges. Look on Lionel's web site and you will find them. Hope this helps you.
There is a special adapter that is needed, you remove the fuel line to the fuel rail, install the special adapter and then install the fuel pressure gauge to the adapter and reinstall the fuel line to the adapter.
Lionel O Gauge Trains can be purchased through Amazon or Ebay, the official Lionel store, and Eric's Trains. Purchasing used is a cost efficient option and going to garage sales, looking at craigslist or kijji may also be a good option to find parts at least for the Lionel Train sets.
No. Lionel is approximately O gauge (1/4 inch to the foot) and S gauge is 3/16 inch to the foot. Lionel has taken a number of liberties in "scaling" their models - some are quite close to accurate but most are not.
There are a wide variety of retail locations and online sites that sell Lionel O Gauge products that can be purchased in or shipped to Pennsylvania. Brookstone, Amazon, and eBay, for example, are all companies that provide this service.
Harold H. Carstens has written: 'The trains of Lionel's standard gauge era' -- subject(s): Lionel Corporation, Models, Railroads
No. But, the adapter in the kit can be modified to fit.
The Lionel company is most famous as a producer and seller of model trains and model train sets. The vast majority of the companies sales come from the O Gauge Trains line.
Create a sharp coat hanger to use it in pressing through the rubber where the electrical goes. ÊPassÊthe temperature gauge through the fire wall. Wrap the end of the gauge in a electrical tape. Install the temperature gauge adapter.
Use an air compressor with an adapter fitting that will allow you to push air in through a spicket on the tank. I made an adapter with a water pressure tester gauge (that is made to attach to a water (hose) spicket.) I then took off the gauge and installed a quick connect air fitting (standard on air equipment and air hoses).
Yes you can! Barbells can be used like a regular gauge.
Normal ear piercings are 18 gauge.
It is normal for a lobe piercing to be 16 or 18 gauge... but it is normally 18. A 16 gauge is normally used for tragus piercings :)