yes it does but under refrigirator
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
Its an hexagonal plug below the exhaust manifold on the side of the engine.
If your Civic is a CX or DX the engine is a 1.5L
According to the Gates website ( they make timing belts etcetera ) ( YES ) The 1.5 liter four cylinder engine in a 1991 Honda Civic ( IS AN INTERFERENCE ENGINE )
To drain the antifreeze on a 1991 Honda Prelude, first ensure the engine is cool. Locate the radiator drain plug at the bottom of the radiator and place a container underneath to catch the fluid. Open the drain plug and let the antifreeze flow out completely. After draining, close the plug and refill the system with fresh coolant as needed.
Have to drop transmission oil pan
To flush the radiator on a 1991 Subaru Legacy, first ensure the engine is cool and remove the radiator cap. Place a drain pan under the radiator and open the drain valve to let the old coolant flow out. After draining, close the valve and fill the radiator with a flushing solution or water, then run the engine for about 10-15 minutes with the heater on to circulate the fluid. Finally, drain the flushing solution, refill with fresh coolant, and check for leaks.
the most lkely reason of coolant leaks to the exterior of the engine is through a breach between the head and block. you should check the gasket first.
The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.
no totally different engine, and engine bay lay out. Smaller engine (civic) cant cool a bigger engine (accord)
To change the thermostat in a 1991 Honda CRX Si, first ensure the engine is cool, then drain the coolant from the radiator. Remove the thermostat housing by unbolting it, and take out the old thermostat. Install the new thermostat with the spring side facing the engine, reattach the housing, and refill the cooling system with coolant. Finally, run the engine to check for leaks and ensure proper operation.
Engine oil- bottom of oil pan Trans- isn't one, have to remove pan Coolant- bottom of radiator Gas tank- isn't one