Ford Probe

Does a 1993 Ford Probe gt 2.5l have forged pistons?


Top Answer
User Avatar
Wiki User
2009-09-18 14:09:30
2009-09-18 14:09:30

they do not come stock with forged pistons, no probe gt does. You will have to buy them and install by yourself

User Avatar

Related Questions

diagram of starter in a 1993 ford probe

ford probe gt rims are 7 inch

Were do I locate the fuel filter on a 1993 Ford probe 4 cylinder

its a Mazda engine . ( DOHC 4cyl. 16 valve 2.0l ) For the probe 1993

Sure but it won't last long stock. If you want to have forced induction you should rebuild the engine with a forged crankshaft, connecting rods, pistons, etc.

Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.

it is located inside the fuel tank

---- ---- == == ---- == == ---- == == ---- == == ---- ---- == == ---- == == == == == == == == == == == == == == == == ----

Brand New 1993 Ford Probe right off the show room floor cost me "$29 800.00"

if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450

The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.

It is important to check and maintain the fluid levels while owning a car. The transmission dipstick of a 1993 Ford Probe is located behind the engine, to close to the firewall and it has a yellow cap.

The 1993 Ford Probe oil filter can be found on the left side of the engine. The oil filter will be near the oil pan. The oil filter is easily seen from the bottom of the engine looking up.

The 93 ford probe came with Mcpherson struts all the way around. I am not sure if the base model included rear shocks, but I doubt it. Stan

Ford Probe was created in 1989.

In the dist. Takeit to Auto zone and have them check it out.

Replace the chain and both the cam and crankshaft gears.

follow the coolant hose that goes under the distributor.

on an automatic trans through dipstick tube

According to the manual, .039-.043 inches.

Can a supercharger work on a 97 ford probe

a 99 ford probe doesnt exist

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.