If you mean the ballast in a fluorescent light fitting where the ballast is wired in series with the tube, the answer is "No". Explanation:
If no tube is in place, the light fitting's circuit is "open" so there is nothing to take any current from the "hot" supply wire and return it to the "neutral" wire.
A ballast is a ballast in most cases. So yes you should be fine.
Are you touching the bulb with your fingers? Oil in the skin causes hot spot on the bulb and causes them to burn out.
This question does is not answerable. A watt is a volt times an amp. With out knowing how many amps the bulbs use there is no answer.
A machine that makes electricity is called a generator. Generators use electromagnetism to convert physical movement into electricity.
Series circuit gives higher resistance compared to parallel circuit.
These tubes need a ballast to operate the tubes. The current and voltage will be marked on the fixtures ballast.
A ballast is a ballast in most cases. So yes you should be fine.
None. Light bulbs use electricity, they do not create electricity.
Yes, there is an excitation current that flows through the primary side of the transformer which is located in the magnetic ballast's casing.
No, they use more electricity.
They use electricity
yes
because light bulbs use electricity ,and candles use fire, and electricity last longer
No, dude bulbs do not use any power.
The filament on normal light bulbs require a higher current of electricity to light up, and are more resistant to electricity as well. This causes it to use more electricity and generate more heat.
Use CFL bulbs. Switch off button when it is not in use.
First you need to determine if it's the ballast that's bad or the emergency ballast. The emergency ballast can go bad and cause the bulbs not to work or not all of them to work depending on the lights wiring setup. Push the test button on the emergency ballast which should have a red glowing indicator light. If all the lights illuminate slightly, change the emergency ballast. It's best to buy the exact ballast for this repair. i.e. If it's a T8 3 lamp fixture. Buy a T8 3 lamp ballast not a 4. You can use a 4 in place of a 3 lamp, but the 3 lamp will be more user friendly. Easiest way is to note what wires go to what. Draw a diagram if you have to and just simply match them back up.