yes you terd
on a clio 172 ph2 (facelift )its not a cable its a sensor its on the gearbox just below the power-steering bottle it will cost you £25.35 On a clio 172 ph1 ( prefaclift) there is a cable, take off inner wing/plastic arch, peel back the sound guard. Once this is done disconnect the cable at both ends.. Next, at the bulk head pull the cable free, thread the new cable in and connect to accelerator and then to the throttle body, put on clip to hold the cable in place... put back sound deading and inner wing, all done..
you should be able to just fit the end of your little finger in and if the tip for your finger is wet then that's enough
no
You can buy a especific kit for your Clio. Go to the k&n site and search for your car. There is also information in pictures, how to fit the kit in your engine. I have tried it on my 1997 1.2 Clio.
To fit a washer pump in a Renault Clio, remove the wipers and scuttle panels. Then undo the 3 nuts. Fit the washer pump and put back the 3 nuts.
I have been looking for a replacement gearbox for my 2000HDi, found that the 1.9 will not fit.
take it to a garage
no
Yes it will, 1.5 dci was mounted in Clio II ph2, and as pH 2 was facelifting without any major changes in construction it should fit without any problems (using parts from pH 2 clio). It may be possible to even fit 1.9 dci engines as non-turbo 1.9 was mounted in clio before 1.5dci was introduced.
yes can
yes it will any saxo/pug gearbox will fit but putting a 1.4 gearbox on a 1.1 will slow the car down as the gear ratio's in the 1.4 gearbox are longer meaning your cars acceleration will be affected