0
Does a full-wave bridge rectifier results in a full secondary volatge at the output?
Wiki User
∙ 13y ago
No. The voltage at the output is the full secondary voltage minus two diode forward bias drops. Depending on current and the specifications of the diode, this total drop could be between 1.5 and 4 volts.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What are the units for volatge?
V = Volts
What is voltage regulation of synchronous generator?
The volatge regaulation be calculated by calculating the percentage difference between volatge at no load and voltage at full load
What is the condition for zero voltage regulation of a single phase transformer?
zero volatge regulation means the terminal volatge of transformer at full load on a given power factor become equal to the rated teriminal volatge of transformer , it happens only for leading power factor in transformer
The primary switching center is a high-volatge switch and?
circuit breaker
What is the SI unit for volatge?
The SI unit is basically the unit it is measured in. In this case it is Volts. (V)
Where is the voltage regulator located on a 1972 Oldsmobile cutlass supreme?
The Volatge Regulator Is Inside The Alternator.
Why didn't the light bulb light up when it was connected to the battery from the wire?
as everybody who realtes to this field knows the volatge for currnet & batterires differs
Why does your radio shack light emitting diode stop blinking after 15 seconds?
A: Check your supply volatge and current . I suggest you have too mauch current
Catera battery and alternator replace volatge gauge still sits like around 13.5 or lower and battery cables hot?
Make sure the Negative cable is well grounded. That may be the problem.
How do you find the secondary to primary transformer voltage ratio?
Turns Ratio = (Primary turns / Secondary turns) To calculate the turns ratio you have to actually know the number of turns or wraps on the primary and secondary coils. Nobody knows that usually the manufacture of the transformer doesn't even know. So what you can use as and equivalent is to calculate the voltage ratio. So what you typically need to look for is the Input voltage and divid it by the output volatge. Usually that would be as follows; (Primary Voltage/Secondary Voltage) = Voltage Ratio
What is a motorcycle voltage regulator?
A voltage regulator converts a/c volatge from the stator to dc voltage and regulates it down to under 15 volts. When they go bad they can over charge and take out a battery as well as not charge at all.
Why you are using the capacitor voltage transformer in Sub station?
To Step down high voltages we require CVT,because it will step down the volatge by uisng capacitor in its circuit.
